Q170226E01.pdf - 第186页
5.27 Feeder Component Sensor and Component Exhaust Sensor Settings SERVICE MANUAL RH5 5.27−1 DA3SEC−83−9K0−A0 5.27 Feeder Component Sensor and Component Exhaust Sensor Settings DA3SEC−83−9K0−A0 Sentence No. LED red LED r…
Pusher
Spring
Shaft
Shaft
Pusher
Gap 0
RH5
5.26 Feeder Unit Feed Pitch and Position Check and Adjustment
SERVICE MANUAL
5.26−4
DA3SEC−83−9J0−A0
Replacing/adjusting feed spring
1. Remove the electronic components mounted
on the Z axis.
2. Cut off the power and air supply and remove
the right top plate of the Z axis.
3. Remove the spring of the feed pusher from
the shaft and then the spring from the end of
the pusher. (Any spring of the two can be
removed first.)
4. Attach a new spring not to have a gap
between the pusher and shaft.
=REFERENCE=
Be sure to attach the spring without any
gap to prevent the clearance to be
changed in feeding the parts cassette.
Added feed limit stopper:
Cam: 0.1
Cylinder:0.1
5.27 Feeder Component Sensor and Component Exhaust Sensor Settings
SERVICE MANUAL
RH5
5.27−1
DA3SEC−83−9K0−A0
5.27 Feeder Component Sensor and Component
Exhaust Sensor Settings
DA3SEC−83−9K0−A0
Sentence No.
LED red
LED red
LED green
LED green
Component
exhaust detection
Feed component
detection
Sensitivity indicator
Sensitivity volume
Timer switch
Mode select switch
Timer control volume
5.27.1 Part name
x Red LED: Indicates incoming light is ON.
x Green LED: Indicates stable operation.
x Sensitivity indicator: Allows volume position to be checked.
x Sensitivity control volume: Enables sensitivity adjustment.
x Timer volume: Timer disabled.
x Mode select switch:
SET o Used when adjusting optical axis (Flashing)
L−ON o Light ON
D−ON o Dark ON.
x Timer switch: Timer available. (Switching is disabled.)
5.27.2 Setting methods
x Sensitivity control volume: Turn the dial gradually from Min. until green and red LEDs light up.
x Timer volume: Any position is permissible.
x Mode select switch:
Feed component sensor: Set to D−ON.
Component exhaust sensor: Set to L−ON.
x Timer switch: Either ON or OFF will do.
RH5
5.27 Feeder Component Sensor and Component Exhaust Sensor Settings
SERVICE MANUAL
5.27−2
DA3SEC−83−9K0−A0
= MEMO =