Q170226E01.pdf - 第208页
5.32 Setting Offset V alues SERVICE MANUAL RH5 5.32−13 DA3SEC−83−9Q0−A0 4. Cancel insertion. x Press ESC three times. x Press F6 (MORE). x Press F1 (MACHINE INITIAL DA T A). x Press F6 (MORE) twice. x Press F2 (SELF−CORR…
Change V4
to V104
RH5
5.32 Setting Offset Values
SERVICE MANUAL
5.32−12
DA3SEC−83−9Q0−A0
Checking Recognition
Operation
1. Call up the NC data edit screen.
x Press ESC twice.
x Press REQ.
x Press F2 (DATA EDIT).
x Press F1 (NC DATA).
x Press F2 (DATA EDIT).
2. Select an NC data for recognition
adjustment.
x Move the cursor to the name of NC data
for recognition adjustment.
x Press ENTER.
x Press F1 (YES).
3. Change V command of the 1st block in
the selected NC data.
x Change V command in the 1st block
from 4 to 104 as shown left.
5.32 Setting Offset Values
SERVICE MANUAL
RH5
5.32−13
DA3SEC−83−9Q0−A0
4. Cancel insertion.
x Press ESC three times.
x Press F6 (MORE).
x Press F1 (MACHINE INITIAL DATA).
x Press F6 (MORE) twice.
x Press F2 (SELF−CORRECTION
CANCEL).
x Set the following data:
3. 1 HOLE/ALL HOLES MEASURE−
MENT: OFF
5. INSERT CANCEL
5. Perform recognition in AUTO mode
(Overwrite NC data)
x Press ESC twice.
x Press F6 (MORE).
x Press AUTO.
x Press EOP.
x Press START.
6. Change to MANUAL mode, choose teaching
mode and select the NC data created for
adjustment.
x Press MANU.
x Press 1 BLK.
x Press F3 (NC DATA TEACHING).
x Move the cursor to the name of NC data for
recognition adjustment using npkeys.
x Press ENTER.
x Press F1 (YES).
RH5
5.32 Setting Offset Values
SERVICE MANUAL
5.32−14
DA3SEC−83−9Q0−A0
7. Move the XY table to the insertion position
of N3 block in the NC data.
x Move the cursor to N3 block using np
keys.
x Press ENTER.
x Press F1 (MOVE).
8. Check the difference between XY
coordinate (a) and XY table displacement
(b).
x Compare the XY table coordinate (a) and
the XY table displacement (b) written
down in 3. Camera Installation Position
Adjustment (6.32−5 (5)). Make sure that
the difference between these values is
within r0.03 mm.
x Check if the guide pin has been aligned
with the center of the board hole.
9. Move the XY table to the insertion position
of N4 block in the NC data.
x Press ESC.
x Move the cursor to N3 block using np
keys.
x Press ENTER.
x Press F1 (MOVE)
10. Check the difference between XY
coordinate (a) and XY table displacement
(b).
x Compare the XY table coordinate (a) and
the XY table displacement (b) written
down in 6.32−11 (3). “Automatic Camera
Offset Measuring (Y Direction)”.
Make sure that the difference between
these values is within r 0.03 mm.
x Check if the guide pin has been aligned
with the center of the board hole.