XP-142E System Reference-SYS-XP142-2.0E.pdf.pdf - 第137页

8.3.4 Copying Boot Parameters As the XP machine cannot be booted up without the proper boot parameters data, the boot parameters must be set. In this step, the default boot parameters will be copied to enable XP machine …

8.3.3 System Backup Data Recovery

If a data backup has been performed on the XP machine, it is possible to restore the data

to the status which existed at the time the backup occurred. After all the copied files

have been processed (see previous page), a dialog box displays to recover the system

backup data.

Procedure

1. Insert the “system backup data disk” in the floppy drive and press [OK] to copy

the backup data. If no backup data is available, press [Cancel] to skip this backup

data recovery step.

If the wrong user backup disk has been inserted, an error dialog box displays

when [OK] is pressed. An error message also displays if the inserted “system

backup data disk” is for a machine type other than that specified prior to copying

the application disks. If this error dialog box displays, press [OK] to return to the

"system backup data recovery" dialog box.

2. If the correct system backup data disk has been inserted, the following backup

data version dialog box displays when [OK] is pressed.

3. Press [Yes] to copy the user backup disk data and perform the recovery.

Press [No] to display a separate backup data recovery dialog box. To skip the

system backup data recovery step, press [Cancel].

Part 2 Chapter 8 System Administration

Edition 2.0 2-8-10 XP-142E System Reference

8.3.4 Copying Boot Parameters

As the XP machine cannot be booted up without the proper boot parameters data, the

boot parameters must be set. In this step, the default boot parameters will be copied to

enable XP machine boot up.

The following dialog box displays after the system backup data recovery step, inquiring

if boot parameters are to be copied.

Press [OK] to copy the default boot parameter settings.

Press [Cancel] to skip this boot parameter copying step.

8.3.5 Rebooting

When the user backup data recovery operation is completed, the following "recovery

complete" dialog box displays.

Remove the disk from the floppy disk drive. Press [OK] to shut down and restart the XP

machine.

Part 2 Chapter 8 System Administration

Edition 2.0 2-8-11 XP-142E System Reference

8.3.6 Error Message Dialog Box

The error dialog box shown below displays at any of the above steps if the wrong floppy

disk is inserted.

Click [OK] to close this dialog box and return to the dialog box requesting that the disk

be inserted.

Part 2 Chapter 8 System Administration

Edition 2.0 2-8-12 XP-142E System Reference