XP-142E System Reference-SYS-XP142-2.0E.pdf.pdf - 第208页

13. Press [OK] to proceed to the template editor screen. Note: The buttons on the template creation screen are explained later. 14. Display the seek lines by selecting the required points. Refer to Part 2 (Template Refer…

11. An image of the picked up part is then captured. Click the arrow button at the

[Edit Area] dialog box, drag the part image to the desired position, then press

[Next].

12. The lines which then display can be moved by dragging them, by entering the

coordinates in the [Calipers] textbox, or by pressing the arrow buttons beside the

textbox. Align the red lines with the part center by aligning the blue and green

lines with the part's top, bottom, left, and right sides. Press [Set Center Point] to

correct the image position, then press [Next].

Part 4 Chapter 2 Creating a Template From Existing Part Data

Edition 2.0 4-2-5 XP-142E System Reference

13. Press [OK] to proceed to the template editor screen.

Note: The buttons on the template creation screen are explained later.

14. Display the seek lines by selecting the required points. Refer to Part 2 (Template

Reference) of the MS Algorithm Vision Processing Reference manual for

information about drawing seek lines for representative part types.

15.

Select the edge position correction function, then correct the position

so that the edge is at the seek line center point. A triangle mark

displays at seek lines selected by the "Find Set" operation.

Part 4 Chapter 2 Creating a Template From Existing Part Data

Edition 2.0 4-2-6 XP-142E System Reference

16.

Select the inspection line display mode, then draw seek lines at the

required points. After drawing the seek lines, repeat the edge position

correction operation (see above).

17.

Select the image position correction function to correct the image

center position and angle.

18.

Select "Close".

19. Select "End Generation" at the dialog box.

20. Displayed lines can be moved by dragging them, by entering the coordinates in

the [Body Size] textbox, or by pressing the arrow buttons beside the textbox. Align

the blue and green lines with the part's top, bottom, left, and right sides, then press

[Next].

Part 4 Chapter 2 Creating a Template From Existing Part Data

Edition 2.0 4-2-7 XP-142E System Reference