XP-142E System Reference-SYS-XP142-2.0E.pdf.pdf - 第24页
4. Safety Labels (ESG0601a) To warn the operator of hazards, safety labels are attached to the machine at the positions indicated in the figure below. Familiarize yourself with each label and its message before operating…
Safety Guidelines
Edition 2.0 9 XP-142E System Reference
WARNING
Do not disable safety switches and leave safety doors
open.
● Do not operate the machine with the safety switches disabled
(shorted), and the MTU detached. Body parts could become caught
in the machine, resulting in serious injury. After removing the MTU,
be sure to close the safety door.
● Do not short or remove the machine's safety switches. An
operation command could be executed by mistake while the safety
switches are disabled, possibly resulting in serious injury.
Check that nothing lies in the direction of movement
before moving the MFU.
● Incorrect handling may cause injury or damage to personnel or
equipement.
Do not move the MFU by applying a sharp push and
then releasing the handle.
● Careless handling could cause an injury or equipment damage.
4. Safety Labels
(ESG0601a)
To warn the operator of hazards, safety labels are attached to the machine at the
positions indicated in the figure below.
Familiarize yourself with each label and its message before operating the machine.
2
3
4
3
2
1
8
7
6
5
Never insert your hand
inside an operating machine.
Moving parts may cause injury.
DANGER
3
1
2
5
7
CAUTION
Direct exposure to the lighting unit
may result in damage to the eyes.
Ensure to use protective eyewear
when necessary.
4
6
<
CAUTION
>
DANGER
Be sure to turn off the power
and wait five minutes before
replacing the flash lamp.
The machine may be damaged
if attempting to remove feeders
during operation.
CAUTION
XP1MZ001E
[High Voltage]
[Danger]
8
WARNING
Do not bypass the machine safety
devices. Use of the machine without
the safety covers is prohibited.
Safety Guidelines
Edition 2.0 10 XP-142E System Reference
9
10
1
11
12
13
1
9
< WARNING >
DISCONNECT POWER PRIOR TO SERVICING.
11
10
Always turn power off
before touching inside!
TOUJOURS COUPER L'ALIMENTATION
AVANT DE TOUCHER A L'INTERUEUR
WARNING
ATTENTION
< CAUTION >
AN EXPLOSION MAY OCCUR IF THE BATTERY IS NOT REPLACED
PROPERLY. USE THE BATTERY TYPE SPECIFIED BY FUJI (OR
EQUIVALENT BATTERY TYPE). USED BATTERIES MUST BE
DISCARDED FOLLOWING THE MANUFACTURER'S INSTRUCTIONS.
13
12
CAUTION
BE SURE TO WEAR THE WRIST STRAP
BEFORE WORKING IN THE CONTROL BOX.
1. TAKE OUT THE WRIST STRAP FROM THE
CONTROL BOX.
2. PUT ON THE WRIST STRAP.
3. START WORK IN THE CONTROL BOX.
XP1MZ002E
[High Voltage]
Safety Guidelines
Edition 2.0 11 XP-142E System Reference