XP-142E System Reference-SYS-XP142-2.0E.pdf.pdf - 第43页
2. Settings Prior to Start Production 2.1 Operation Settings (ESR0203h) The machine operation conditions are specified by the following 5 setting items (4 settings when “local verify” is not used). • Mode selection: Spec…
1.4 Stopping the Buzzer
(ESR0232a)
The method for stopping a sounding buzzer is described below.
Procedure A
• Click the [FUJI] logo at the top left of the screen to display the screen shown
below, then click the [Buzzer Off] button.
Procedure B
• The buzzer is turned off when the CYCLE STOP switch is pressed.
Part 2 Chapter 1 Basic Operation
Edition 2.0 2-1-4 XP-142E System Reference
2. Settings Prior to Start Production
2.1 Operation Settings
(ESR0203h)
The machine operation conditions are specified by the following 5 setting items
(4 settings when “local verify” is not used).
• Mode selection: Specifies the mode of machine operation (Production mode,
operation mode, etc.)
• Tape cutter: Settings for the upper tape cutter used when supplying parts
on tape reels.
• Statistical information: Settings which determine how nozzle & slot error data are
collected.
• Local verify (optional): Settings for the parts set position verify operation performed
by the barcode reader.
• Other: Settings related to panel vacuum and nozzle size checks.
Display example
1. Displays the currently opened page name.
The “page count / total number of pages” of the currently opened page displays.
2. [Close]
Press to close the [Operation Settings] screen and return to the [Main] screen.
3. Page switching buttons
Press [Previous page] to go back 1 page. If [Previous page] is pressed at page 1,
the final page displays. Press [Next page] to advance 1 page. If [Next page] is
pressed at the final page, the first page (page 1) displays.
Part 2 Chapter 2 Settings Prior to Start Production
Edition 2.0 2-2-1 XP-142E System Reference
2.1.1 Production Mode
There are four modes of production: “Product”, “Idle 1”, “Idle 2”, and “Pass”. Details of
each mode are explained below.
Product: This mode is used during assembly. Parts are picked up, inspected, and
placed on the panel.
Idle 1: This mode is selected primarily for machine adjustment and test run
operations. The nozzle moves to the part pickup position, and actually feed
the part. The feeder should be removed from the MFU to prevent parts
from being scattered.
Idle 2: This mode is selected primarily for machine adjustment and test run
operations. In this mode, the nozzle moves to the part pickup position, but
does not feed the part. It is not necessary to remove the feeders from the
MFU.
Pass: Pass mode is used when the machine is not used in current production. In
pass mode the machine simply acts as a conveyor, moving the panel on to
the next machine in the line.
Procedure
1. At the [Main] screen, press [Maintenance A] then [Operation Settings] to display
the [Operation Settings] screen.
2. Select the desired mode from the “Product”, “Idle 1”, “Idle 2”, “Pass” candidates
at the upper left of the screen.
3. Press [Close] to return to the [Main] screen.
Part 2 Chapter 2 Settings Prior to Start Production
Edition 2.0 2-2-2 XP-142E System Reference