KE2010.Instruction Manual.Ver.2.01,Rev.08.pdf - 第428页

6 − 52 (2) Feeder infor mation W hen you select the [Tool] command f rom t he menu bar, t he [Error log] command on the displayed menu, then t he [Supplier inf ormat ion] command af t er production, the screen shown belo…

100%1 / 1361
6 − 51
6.3.1 Retry List display after the end of board production
(1) Unplaced list
To call the retry list after board production ends, select the [Tool] command from
the menu bar, the [Error log] command on the displayed menu, then the
[Unplaced list] command.
The screen shown below (Unplaced list) in Figure 6.3.1.1 appears on the screen.
In this list, up to 100 retry errors per each station can be displayed in the order in
which the errors occurred. However, the Retry List (Supplier information) screen
in Figure 6.3.1.2 appears if there is any feeder which failed to pick up a
component although all components were placed on boards. If all components
are picked and placed, no error appears on the screen.
Figure 6.3.1.1 Retry List (Unplaced list) screen
6 − 52
(2) Feeder information
When you select the [Tool] command from the menu bar, the [Error log] command
on the displayed menu, then the [Supplier information] command after production,
the screen shown below in Figure 6.3.1.2 appears.
In this list, up to 100 errors can be displayed.
Figure 6.3.1.2 Retry List (Supplier information) screen
6 − 53
6.3.2 Retry list display during board production
In the execution of production, the error list whose contents vary depending on the
error actually occurred appears on the screen as shown in Figure 6.3.2.1.
Figure 6.3.2.1 Retry List display dialog box (Supplier information)
The error log displayed in the execution of production is used to determine whether or
not the production should be continued.
Therefore, with eight buttons displayed on the screen, control the production condition
after an error occurs. The function activated with your button selection is described
below.
1) Laser crimp disp.
This button displays the laser waveform. See the description of the laser
waveform display under Section 6.4.8 “Checking to see if a laser head is stained”
for details.
1)
2) Retry
When you select the "Retry" button, the following dialog box appears on the
screen as shown in Figure 6.3.2.2.
Figure 6.3.2.2 Dialog box displayed when you select the <Retry> button