KE2010.Instruction Manual.Ver.2.01,Rev.08.pdf - 第630页
8 − 41 8.4 VCS Control 8.4.1 VCS control (supported by a KE-2020 and KE-2040) W hen y ou select t he [Vision] command on the [Ctr l] menu, t hen the [Vision control] command, t he following "VCS cont rol" dialo…
8 − 40
1) Vacuum
When the radio button “Vacuum” is checked, you can turn on/off vacuum of
the vacuum table.
When the radio button “Vacuum” is checked, click the <ON>, <OFF> or
<ON/OFF> button or press the F3, F4 or F5 button.
The “State” display is updated when the selected vacuum function is
controlled completely.
2) Blow cont
When the radio button “Blow cont” is checked, you can turn on/off the blow
function of the vacuum table.
When the radio button “Blow cont” is checked, click the <ON>, <OFF>, or
<ON/OFF> button, or press the F3, F4 or F5] key.
The state display is updated when the selected blow function is controlled
completely.
3) Support table
When the radio button “Support table” is checked, you can move up or
down the support table.
When the radio button “Support table” is checked, click the <UP>,
<DOWN> or <UP/DOWN> button, or press the F3, F4 or F5] key.
(3) State
This column shows the condition of each unit when controlled completely.
8 − 41
8.4 VCS Control
8.4.1 VCS control (supported by a KE-2020 and KE-2040)
When you select the [Vision] command on the [Ctrl] menu, then the [Vision control]
command, the following "VCS control" dialog box appears on the screen.
Figure 8.4.1 VCS control dialog box
(1) Control unit
Select a unit to be controlled from the combo box.
Note that you cannot select a unit whose view type is not set (that is, not
installed) with the "Option" menu of the MS parameters.
This selection will not affect the setting of the "Device enable" dialog box invoked
from the Machine setup menu (you can select a unit not checked (that is, not
enabled)).
* When you press the down arrow key while holding down the Alt key, the
following list appears on the screen.
(KE-2020) (KE-2040)
8 − 42
(2) Control head
Select a head to be controlled from the combo box.
This selection will not affect the setting of the "Device enable" dialog box invoked
from the Machine setup menu (you can select a unit not checked (that is, not
enabled)).
Note: You can select the FMLA head only.
* When you press the down arrow key while holding down the Alt key, the
following list appears on the screen.
(KE-2020) (KE-2040)
(3) Control item
Select a control item with the corresponding radio button.
(4) Control button
With the control button, execute the control item you selected.
The displayed control buttons vary depending on the control item you selected.
1) Back light
This control item turns on and/or off the back light.
- When the control item "Back light" is checked, click the <ON>, <OFF> or
<ON/OFF> button or press the F3, F4 or F5 key to control the back light.
- If you click the <Setting> button or press the F6 key when the control item
"Back light" is checked, the "Light setting" dialog box appears on the
screen.
The state of the back light is updated when the back light is controlled
completely.