KE2010.Instruction Manual.Ver.2.01,Rev.08.pdf - 第508页
6 − 132 6.7.1.4. 2 “Execut ing conti nuous verification…” di alog box W hile the system is perfor ming a verif ication check cont inuously, the f ollowing dialog box appears on the screen. − On this dialog box, the syste…
6 − 131
− Range of verification
Check this check box if you want to check the components whose numbers
are specified by you.
− When you check this check box, you can specify the following items:
Figure 6.7.1.4.3 Range of verification
①
Start compo. No.
Check this check box if you are to specify the number of the first component to
be checked. After checking this check box, enter the first component number
in the edit box.
②
End compo. No.
Check this check box if you are to specify the number of the last component to
be checked. After checking this check box, enter the last component number
in the edit box.
③
Only placement compo.
Check this check box to check only components whose data is stored in
Placement data.
− <VERIFY> button
Starts the continuous verification check.
− <Exit> button
Returns to the pervious screen displayed before you invoke this dialog box.
− Shortcut keys
On the “Continuous verification” dialog box, the following shortcut keys are
available.
Table 7.7.4.4.1 Shortcut keys
Keyboard Operation panel HOD key Action
START Starts the continuous verification check.
ESC Returns to the previous screen.
6 − 132
6.7.1.4.2 “Executing continuous verification…” dialog box
While the system is performing a verification check continuously, the following
dialog box appears on the screen.
− On this dialog box, the system displays the data on a component being
checked, how far the check progresses, and the check result.
Figure 6.7.1.4.4 “Executing continuous verification…” dialog box
6.7.1.4.3 Interruption dialog box
To interrupt the inspection being executed forcibly, press the <STOP> button.
The following dialog box appears on the screen.
− Select whether to stop the inspection or not.
Figure 6.7.1.4.5 “Question” dialog box for interrupting the current inspection
6 − 133
6.7.1.4.4 Continuous inspection error dialog box
If the inspection result indicates “NG”, the following dialog box appears and it
allows you to enter the system to Single Inspection mode.
Figure 6.7.1.4.6 Continuous inspection error dialog box
6.7.1.4.5 End of continuous inspection
When the system finishes checking all components you specified, the following
dialog box appears that notifies you of end of continuous inspection.
Figure 6.7.1.4.7 End of inspection dialog box