KE2010.Instruction Manual.Ver.2.01,Rev.08.pdf - 第522页

6 − 146 (1) Setting check conditions If you enter Single check mode when a continuous check err or occurs, the following "I nspection" dialog box appears on t he screen. Inspection di alog box 1) Component of i…

6 − 145

4) End of continuous check

When the system finishes checking all components which satisfy the

conditions you specified, the following dialog box appears on the screen.

Figure 6.7.2.5.2.6 "Information - end of Continuous laser position

inspection" dialog box

6.7.2.5.3 Single inspection

• When you click the <INSP.> button (F10 key), the system starts checking a

component. When it finishes checking the component, the result appears on

the screen.

• When you click the <MEAS.> button (F10 key), the system starts measuring a

component. When it finishes measuring a component, the result appears on

the screen.

• On the "Inspection" screen, you can manually enter the pick-up position or use

the teaching function to enter it. When you check the check box "The taught

result is reflected in the pick data.", the taught data is stored into Pick data.

• On the "Laser position measurement" screen, pressing the NEXT or

PREVIOUS key of the HOD or the F5 or F6 key moves the component pick-up

position to the alternative component.

• In Continuous check mode, pressing the <START> switch resumes the

continuous check.

6 − 146

(1) Setting check conditions

If you enter Single check mode when a continuous check error occurs, the

following "Inspection" dialog box appears on the screen.

Inspection dialog box

1) Component of insp. (inspection)

The description of a component to be inspected and its pick-up position

are displayed here.

2) Inspected value

The laser height of a component to be inspected ("LA Pos") and its height

(Compo. height) are displayed here.

6 − 147

3) <MEAS.> button

This button measures the laser height.

(See Section 6.7.2.5.4 "Measuring laser height".)

4) Pickup position

The pick-up position of a component is displayed here. You can change

the pick-up position to the previous alternative component or next one.

① <FEED> button

This button knocks a feeder (other than a 32-mm paper tape feeder)

once to feed a component.

② "The taught results reflected in the pick data."

Check this check box if you want to store the result taught by the

HOD device into Pick data. When unchecked, only the coordinates

of the current pick-up position are applied to Pick data.

5) Result of inspection

After checking laser height, the result is displayed in this "Result of

inspection" column. The "Short side" and the "Log side" indicate the data

obtained when the system detects the minimum width of a component for

the first time and second time respectively. These values are effective

only when each status of the "Short side" and "Long side" is "OK".

① Status

OK: Centering is done successfully.

Number: Centering failed. (Each number indicates the error code

number of the laser status.)

② Outline

The width of a component which is detected with laser when the

component is centered successfully is displayed here.

③ Angle

The angle obtained when a component is centered is displayed here.