Omron V-TS Teaching Manual.pdf.pdf - 第217页
Chapter 2 Insp ection Progr amming 2- 190 3. The deletion confirm ation dialog appears. Cl ick [OK]. ・ Click [Cancel] to retur n to the PCB im age managem ent screen without deleting the PC B im age.
2.16 Managing PCB Images
2-189
2.16.2 Deleting a PCB Image
This section explains the procedure to delete bare PCB and inspection PCB images, which are
not required for teaching.
1.
Select the image type (bare PCB image or inspection PCB image)
to display in the PCB Image Management screen from the list.
2.
Click to select the image to delete in the Board Image List, and click
[Delete Image]. More than one images can be selected. The
method to select them is as follows:
1) Ctrl Key + Select an image: Selection of the image corresponding
to the key pression can be set ON/OFF.
2) Shift Key + Select an image: The entire area from the start point
to end point of key pression can be selected.
All the images can also be selected by pressing Ctrl Key + A Key.
However, it is necessary to leave at least one image in the raw
PCB list and the inspection PCB list from the PCB image list,
respectively. If only one image is left in the raw PCB list or the
inspection PCB list from the PCB image list, the [Delete Image]
button is not enabled.
Operation
Chapter 2 Inspection Programming
2-190
3.
The deletion confirmation dialog appears. Click [OK].
・Click [Cancel] to return to the PCB image management screen
without deleting the PCB image.
2.16 Managing PCB Images
2-191
2.16.3 Editing Models by the Unit of PCB
This section describes a procedure to edit the model on a per PCB basis.
1.
Select "Inspection PCB" in the PCB Image Management screen if
the Board Image List contains bare board images.
2.
Click to select the inspection PCB image to edit in the Board Image
List and click [Edit Model].
The color table editing tool is displayed.
Operation