Omron V-TS Teaching Manual.pdf.pdf - 第46页

2.1 Bas ics of Teaching 2- 19  Create Window W hen creating a w indow, set the display magnification to 1.0 times or higher. A window in a size smaller than 0.1 mm × 0.1 mm cannot be created. 1. Click (Create W indow) o…

100%1 / 350
Chapter 2 Inspection Programming
2-18
Change Magnification Ratio
<Magnify/Reduce>
The image can be enlarged or reduced in the following three ways:
1) Click (Magnify) button or (Reduce) button in the Image Operation tool bar.
2) Move the slide bar up or down in the Image Operation tool bar.
Move it upward to magnify, and downward to reduce.
3) Position the mouse cursor on the image display area and rotate the mouse wheel.
Rotate it upward to magnify, and downward to reduce.
The magnification ratio changes by one step increment as shown below:
Maximum reduction ratio
x0.01 -> … ->
…
-> x0.25 -> x0.50 ->
×
1.00 -> x2.00 ->
…
-> x4.00
<Original Size Display>
1.
Click (Original Size) button in the Image Operation tool bar.
The software displays one pixel of the camera image in the same
size (100%) as one pixel of the image display area.
<Entire PCB Display>
1.
Click (Entire View) button in the Image Operation tool bar.
The entire PCB view is displayed.
Operation
Operation
2.1 Basics of Teaching
2-19
Create Window
When creating a window, set the display magnification to 1.0 times or higher.
A window in a size smaller than 0.1 mm × 0.1 mm cannot be created.
1.
Click (Create Window) or (Create Mask Window) button
in the Image Operation tool bar.
2.
Move the mouse cursor at the top left corner of the window to
create, surrounding the relevant location e.g. component or land.
3.
Drag the cursor from the left top point diagonally to the right bottom.
4.
Drop the cursor. The window is formed.
Operation
Chapter 2 Inspection Programming
2-20
Change Window Size
When adjusting a window, set the display magnification to 1.0 times or higher.
1.
Click (Select Window) or (Create Window) button in the
Image Operation tool bar.
2.
Click the window in the image display area to resize.
3.
Position the mouse cursor on an operating point (shown in a small
square) on the window.
The mouse cursor changes from to .
The window which can be resized or moved is different
depending on the screen. For details, refer to 2.15.1 “Modifying an
Inspection Window.”
The direction of the mouse cursor changes depending on the
operating point to choose, as shown below:
4.
Drag and drop the selected operating point in the window to resize.
Operation
書式変更: フォント : Arial
削除: Modifying an Inspection Window