Omron V-TS Teaching Manual.pdf.pdf - 第3页
2 PCB Inspection System T eaching Manual Before Y ou Begin Before Y ou Begin, T able of Contents Chapter 1 Before Getting S tarted Chapter 2 Inspection Programming Chapter 3 Management Menu Appendix T eaching Flow
1
Before You Begin
Thank you for purchasing the PCB inspection system.
The PCB inspection system is the equipment used to inspect soldering or component
implementation conditions and display the inspection results.
When using this system, observe the following:
- Read this manual carefully to understand the contents well, and make the proper use of
this system accordingly.
- Keep this manual safely for ready reference at any time.
- For the basic operation of this system, also read the relevant manuals carefully to
understand the contents well, and then make the proper use of this system accordingly.
Intended Readers
This manual contains the information concerning the basic operation of inspection and image
capturing. Readers of this manual should have undergone the previous PCB inspection
system training with Omron Corporation.
2
PCB Inspection System
Teaching Manual
Before You
Begin
Before You Begin, Table of Contents
Chapter 1
Before Getting Started
Chapter 2
Inspection Programming
Chapter 3
Management Menu
Appendix
Teaching Flow
3
Read and Understand this Manual
Please read and understand this manual before using the products. Please consult your
OMRON representative if you have any questions or comments.
Warranty and Limitations of Liability
The ordering or use of Omron products implies your agreement to the Terms and
Conditions described below, unless otherwise is specifically agreed.
1. Definition
The definitions used in these Terms and Conditions are as follows:
(1) Omron products: Omron branded automated optical inspection (AOI) machine
and peripheral software to be used with Omron branded AOI machine
(2) Catalogues: Introduction brochure of products, specifications, instructions and
manuals of Omron products, including electronically provided information
available on the Omron electronic components information website, etc.
(3) Usage conditions: Usage conditions, rating, performance, operating
environment, handling instructions, cautions, prohibited use, etc. of Omron
products described in specifications, documentations or manuals.
(4) Customer application: Application of Omron products by customers which using
Omron products as equipments or system components.
(5) Fitness: (a)Fitness, (b)performance, (c) non-infringement of third-party
intellectual property, (d) compliance with laws and regulations and (e)conformity
to various standards.
2. Caution on Descriptions Using Catalogues
Attention is required to the following points for information obtained from
Catalogues:
(1) Rated values and performance values are the product of tests performed for
separate single conditions, including but not limited to temperature and
humidity. Omron does not warrant rated values and performance values for
multiple combined conditions.
(2) Reference data are provided for reference only. Omron does NOT warrant that
Omron products work properly at all times in the range of reference data.
(3) Application examples are provided for reference only. Omron does NOT warrant
the Fitness of Omron products under such applications.
(4) Omron may discontinue the production of Omron products or change the
specifications of them for the purpose of improving such products or other
reasons entirely at its own discretion.
3. Precautions
Please be aware of and accept the following when you introduce or use Omron
products:
(1) Please use Omron products in compliance with usage conditions including
rating and performance limits.
(2) Please confirm the fitness of Omron products in your application and use your
own judgment to determine the appropriateness of using them in such
application. Omron shall not warrant the fitness of Omron products in customer
applications.
(3) Please confirm that Omron products are properly wired and installed for their
intended use in your overall system.
(4) When using Omron products, please make sure to conduct regular maintenance
on Omron products.
(5) Omron products are designed and manufactured as general-purpose AOI and
peripheral software for using in SMT Line. If you are using Omron products in the