Omron V-TS Teaching Manual.pdf.pdf - 第53页
Chapter 2 Inspection Programm ing 2- 26 Click [New Inspectio n Program] to add a ne w inspection program for an existing PCB after s electing the PCB in t he Inspection Program List. 3. The PCB Inform ation Setting scree…
2.2 Creating a New Inspection Program
2-25
2.2 Creating a New Inspection Program
This section describes the procedure to create a new inspection program.
1.
Click [Teaching] in the main menu.
2.
The Select PCB screen appears.
To create an inspection program for a new PCB, click [New PCB].
Chapter 2 Inspection Programming
2-26
Click [New Inspection Program] to add a new inspection program for
an existing PCB after selecting the PCB in the Inspection Program
List.
3.
The PCB Information Setting screen appears.
Enter the PCB and inspection program information and click [OK].
Click [Cancel] to abort the setting and return to the Select PCB
screen.
2.2 Creating a New Inspection Program
2-27
Board Information
* The board information cannot be edited except “Has Bare Board”
and “Adjust Block Position Individually” if [New Inspection Program]
is clicked in Step 2.
■ Component Number Library
Specify the component number library to use for a PCB to create.
The component number library can be edited through Utility -
Component Number Library Management Screen.
■ Board Name
Enter the name of the PCB to create within 32 single-byte
alphanumeric characters/symbols.
Both upper and lower case alphabet characters can be used.
However, they are not distinguished.
■ Has Bare Board
Set availability of bare board. When there is no bare board, click
the check box to turn it OFF. Individual land window auto
adjustment is not available, if the checkbox is turned OFF.
If the checkbox is OFF, bare PCB image capturing cannot be
skipped. Capture the inspection PCB image instead.