MR8740、MR8741_user_manual_eng_20191016H.pdf - 第394页
18.6 Cleaning 382 To clean the instrument and modules wipe it gently with a soft clo th moistened with water or m ild detergent. 18.6 Cleaning Cleaning the Instrument and Modules Never use solvent s such as benzene, alc …
18.5 Updating the Instrument
381
Chapter 18 Maintenance and Service
14
18
If the version update file is not displayed on the File screen
The possible causes are as follows.
(Example: When the version update file is saved in the "HIOKI_MR8740" folder of the USB mem-
ory stick)
Wrong media is selected
Check the address displayed at the top of the screen.There is no problem if the address begins
with "USB1".
• If the address does not begin with "USB1":
Click [Change Media] on the right of the File screen and then click [USB Stick] in the displayed
list.
Wrong folder is selected
Check the address displayed at the top of the screen. There is no problem if the address is
"USB1:\HIOKI_MR8740\".
• If the address does not begin with "USB1:\HIOKI_MR8740\":
Left-click the part enclosed by a red line in the figure below until "USB1:\" is displayed for the
address. When it is displayed, double-click the HIOKI_MR8740 folder in the list.
Click [Change Media].
Click [USB Stick] to switch to the
USB memory stick.
Click the part enclosed by a red line until "USB1:\" is displayed, and then double-click the
18.6 Cleaning
382
To clean the instrument and modules wipe it gently with a soft cloth moistened
with water or mild detergent.
18.6 Cleaning
Cleaning the Instrument and Modules
Never use solvents such as benzene, alcohol, acetone, ether, ketones, thinners
or gasoline, as they can deform and discolor the case.
18.7 Disposing of the Instrument (Lithium Battery Removal)
383
Chapter 18 Maintenance and Service
14
18
The instrument contains a lithium battery for memory backup. Remove this battery before disposing of the
instrument.
Procedure ____________________________________________________
Required tools:
Phillips screwdriver, wire cutter: One each
Box wrench or long-nosed pliers
1. Verify that the power is off, and remove the connection cables and power cord.
2. Remove the screws and each parts as indicated in the next page diagram.
3. Pull the lithium battery up from the circuit board, and cut the two leads with a
wire cutter.
4. Remove the battery from the board.
18.7 Disposing of the Instrument (Lithium Battery
Removal)
• To avoid electric shock, turn off the power switch and disconnect the power
cord and connection cords before removing the lithium battery.
• Keep batteries away from children to prevent accidental swallowing.
• Battery may explode if mistreated. Do not short-circuit, recharge, disassemble
or dispose of in fire.
When disposing of this instrument, remove the lithium battery and dispose of
battery and instrument in accordance with local regulations.
CALIFORNIA, USA ONLY
Perchlorate Material - special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/perchlorate