KJ-01.02.Instruction Manual.REV.02.pdf - 第278页
8 − 11 CHAPTER 8 PRODUCT IO N PROCEDURE 8.1 Preparat ions for Production 8.1.1. Pr eparations of the com ponent supplying section 8.1.2 Prepar ations of the A T C 8.1.3 Prepar ations of the PW B transport section 8.1.4 W…
8 − 10
Figure 8.1.3.9 Figure 8.1.3.10
WARNING
To prevent the body from injury that can be caused by accidental
activation of the machine, turn off the power of the machine before
starting to work.
(2) Compensation
Follow the description of Section 7.4 “Trial Production”, test-place components
on a working PWB and check for the deviations between elements and pads.
When detecting any deviation, compensate its X and Y coordinates in
"Placement offset" in Production mode.
,
Figure 8.1.3.11
Pad
Pad
Element
Element
8 − 11
CHAPTER 8 PRODUCTION PROCEDURE
8.1 Preparations for Production
8.1.1. Preparations of the component supplying section
8.1.2 Preparations of the ATC
8.1.3 Preparations of the PWB transport section
8.1.4 Warming up
8 − 12
When you click the <END> button, the machine finishes the warming-up operation.
As a warming-up operation, the machine turns on and off each air cylinder ten times
repeatedly. Then, the machine operates the XY-axis, Z-axis, and theta axis, and
rotates the PWB transport motor.
CAUTION
The XY-axis starts moving immediately after you press the ENTER
key, and the machine starts warming up. To avoid risk of injury, do not
place your hand in the machine, nor move your face or head close to
the machine while you are operating the HOD.
Before pressing the ENTER key, check to see if there is no one who is
working the internal parts of the machine.
Before pressing the ENTER key, check to see if there is no one who is
near the machine and can be injured when the machine warms up.
Before pressing the ENTER key, check to see there is no obstacle
(tools and jigs) attached or left in the machine that may prevent any
part inside the machine from operating.