KJ-01.02.Instruction Manual.REV.02.pdf - 第36页
1 − 20 1. Feeder bank parts ident ificat ion (See Figure 1.2. 3.2.) T he tape f eeder loaded with taped component s, bulk f eeder , and stick feeder loaded with components in sticks are positioned and secured by the f ix…
1 − 19
1.2.3 Component feeder
The component feeder has two banks located at front and rear to sandwich the PWB
transport unit. It may be a tape, stick, or tray feeder depending on the applicable
component package.
The tape feeder or stick feeder is installed to the feeder bank to feed taped
components or ones in sticks.
Tray are supplied by a tray holder, or tray feeder is installed on the rear side.
(
)
Figure 1.2.3.1
Feeder banks
PWB
Rear
Front
PWB transport unit
1 − 20
1. Feeder bank parts identification (See Figure 1.2.3.2.)
The tape feeder loaded with taped components, bulk feeder, and stick feeder
loaded with components in sticks are positioned and secured by the fixing plate
② , fixing plate B ③, and lock shaft ④ .
The tape feeder is driven by the drive cylinders ⑤ .
The position label ⑥ is used to determine the position at which each feeder is
installed.
① Feeder bank ④ Lock shaft
② Fixing plate ⑤ Drive cylinder
③ Fixing plate B ⑥ Position label
Figure 1.2.3.2
1 − 21
2. Tape feeder parts identification
The tape feeder uses a tape whose width is 8 mm, 12 mm, 16 mm, 24 mm, or 32
mm to supply components.
FF05/08 Parts identification (1/2)
12
11
10
16
4
17
6
5
1
2
14
19 15 13
18
Figure 1.2.3.4 Right side view
① X axis reference pin A ⑧ Stopper ⑮ Guide cover
② X axis reference pin B ⑨ Free link ⑯ Unreeling plate
③ Sprocket wheel ⑩ Tape holder ⑰ Unreeling guide roller
④ Upper cover ⑪ Cover tape fixing plate ⑱ Reel support
⑤ Upper cover hook ⑫ Lock release lever ⑲ Tape groove
⑥ Shutter ⑬ Lock holder
⑦ Knock lever ⑭ Tape guide
18
12
9
4
5
16
8
7
3 13
Figure 1.2.3.5 Left side view