KJ-01.02.Instruction Manual.REV.02.pdf - 第386页
14 − 17 14.3.5 A TC ① Mounting base ⑥ A TC CLO SE sensor ② A T C base ⑦ No zzl e ③ Slide plate ④ Air cylinder ⑤ A T C OPEN sens or Mov e the slide plat e and clean the A T C base with a wiping rag or similar mater ial li…
14 − 16
14.3.4.3 Applying oil or grease to a nozzle after cleaning
After using ethanol or isopropyl alcohol (IPA) to clean a nozzle with an ultrasonic
cleaner, use a cotton swab to apply New Deflex Oil No. 1 (JUKI P/N:
MDFRX1001L0) between the nozzle outer and the outer SP holder. After greasing,
use an air gun or similar device to blow excessive oil and remove the remaining oil
with a wiping rag.
To make the nozzle outer slide smoothly, first apply Albania grease
(a-rice-grain-sized amount) to the tip of a toothpick, and apply this grease to the
area shown in Figure 2 (area between the nozzle outer and the outer SP holder).
Push up the nozzle outer, and apply grease (ball-sized amount of grease) to each of
three balls respectively. Move the nozzle outer up and down 20 to 30 times to
apply grease over the nozzle outer uniformly.
Be careful not to apply any oil or grease to the shaft label.
Figure 2 How to apply grease
WARNING
Solution is flammable. Be careful to handle it.
Never use acetone. It may discolor the nozzle diffuser.
During greasing, be sure to wear a protective mask for organic gas. IPA
contains substances harmful to human bodies.
Cotton swab
S
ma
ll
tra
y
New Deflex Oil No. 1
Nozzle outer
Wiping rag
Cotton swab
Outer SP holder
Area to be greased
Toothpick
Nozzle outer
Ball
20 to 30 times
Toothpick
14 −
17
14.3.5 ATC
① Mounting base ⑥ ATC CLOSE sensor
② ATC base ⑦ Nozzle
③ Slide plate
④ Air cylinder
⑤ ATC OPEN sensor
Move the slide plate and clean the ATC base with a wiping rag or similar material
lightly dampened with alcohol.
WARNING
To prevent the body from injury which can be caused by accidental
activation of the machine, cut off the power to the machine before starting
to work.
Cut side
14 − 18
14.3.6 Feeder bank
Clean the surface of the feeder bank with dry cloth before mounting feeders such a
tape feeder there.
Clean the feeder bank with dry cloth so that the fixing plate B ③ is free from
obstacles.
Using a vacuum cleaner, clean the feeder bank if there are chips or some foreign
matters remained on it.
① Feeder bank
(Side on which the
bank is installed)
② Fixing plate
③ Fixing plate B
④ Lock shaft
⑤ Drive cylinder
WARNING
To prevent the body from injury which can be caused by accidental
activation of the machine, cut off the power to the machine before starting
to work.
14.3.7 Z slider shaft
Clean the inside of the Z slider shaft with a cotton swab moistened with alcohol from
the bottom.
Cotton swab
WARNING
To prevent the body from injury which can be caused by accidental
activation of the machine, cut off the power to the machine before starting
to work.