KJ-01.02.Instruction Manual.REV.02.pdf - 第81页
4 − 10 4.3.1 A TC nozzle setup W hen you select the [1/ A TC nozzle setup] command f rom t he [1/Set up g roup] menu, the “ A TC nozzle setup” dialog box appears on the scr een as shown in Figure 4. 3.1.1. Figure 4.3. 1.…
4 − 9
(3) Saving the settings
Although push buttons “OK” and “Cancel” are available with each setting group,
pressing the OK button will not save the data to the Flash memory.
If [9/ Exit] is selected from [9/ Exit] displayed on the menu bar, or if [9/ Exit] is
selected from the [1/ Set up group] menu, a dialog box appears asking you
whether you save the settings or not. The setting data is saved to the Flash
memory if you answer “Yes”.
Figure 4.3.10 Save confirmation screen
Table 4.3.2 Save confirmation buttons
No. Button
Effect
1 Yes Saves the setting data to the Flash memory and quits the machine setup mode.
2 No Cancels the setting data and quits the machine setup mode.
3 Cancel Cancels the exit command.
4 − 10
4.3.1 ATC nozzle setup
When you select the [1/ ATC nozzle setup] command from the [1/Set up group]
menu, the “ATC nozzle setup” dialog box appears on the screen as shown in
Figure 4.3.1.1.
Figure 4.3.1.1 ATC nozzle setup dialog box
No. Item Description
1 Nozzle number Nozzle number to be allocated to ATC
2 Vacuum value The vacuum value with the nozzle attached (for automatic operation only)
3 Nozzle height The offset of length with respect to the standard nozzle (for automatic operation only)
(1) Setting items
① Setting the nozzle no.
– A character displayed under “ATC No.” indicates the number assigned to
the ATC. Enter the number of a nozzle you want to assign to the ATC.
– You can set a value to the nozzle number on which the input focus is
located. Validate your entering data with pressing the ENTER key or filed
selection key.
– Eight nozzle numbers, 501, 502, 503, 504, 505, 506, 507 and 508 can be
entered as a nozzle number at the initial sate. When you install a new
nozzle with following the procedure described at Section 4.3.10 “Nozzle
data installation,” you can enter the number of the new nozzle here.
– When you erase the entered character(s) with the Delete key or back
space key, or with the space key in Overwrite mode, and then validate
your erasing data with the ENTER key or filed selection key, the
corresponding nozzle is released and the data displayed as “Vacuum” is
cleared.
4 − 11
② Setting the vacuum value
– Set the vacuum value when a nozzle is mounted.
– When you click the <EXEC.> button, the vacuum value is automatically
obtained. You can enter characters to the “Vacuum” column on which
the input focus is located also.
③ Setting the nozzle height
– Set the offset value of the mounted nozzle with respect to the reference
nozzle.
– When you click the <EXEC.> button, the nozzle height is automatically
obtained. This item can be entered automatically only.
(2) Purpose of usage
– The machine judges whether a nozzle is attached or not with checking these
settings and the setting of the next item “Vacuum value without nozzle”
together.
– The machine samples the vacuum value before picking up a component, and
then samples it also after picking up a component to check whether a
component is located at the pick-up position based on the difference of these
sampled values.