KJ-01.02.Instruction Manual.REV.02.pdf - 第336页
10 − 11 10.4.2 Head control W hen y ou select the [ 2/Head] command on t he menu bar , and then the [ 1/Head control] com mand, the dialog box for controlling the head appears as shown in Figure 10.4.2.1. Each command is…
10 − 10
When you select the [4/A given Z coordinate move] command, the dialog box
appears, which asks you to enter the coordinate of the position the nozzle is
supposed to move to as shown in Figure 10.4.1.2.2. When you enter the Z
coordinate in the same manner as the XY coordinates and click the <MOVE> button,
the nozzle moves as instructed. Enter the Z coordinate with regarding the height a
board is located as “0”, the upper position as a positive value and the lower position
as a negative value.
CAUTION
The Z-axis starts moving immediately after you press the <MOVE>
button.
To avoid risk of injury, do not place your hand in the machine, nor move
your face or head close to the machine during operation.
Before pressing the <MOVE> button, check to see if there is no one
who is working the internal parts of the machine.
Before pressing the <MOVE> button, check to see if there is no one
who is near the machine and can be injured when the machine warms
up.
Before pressing the <MOVE> button, check to see there is no obstacle
(tools and jigs) attached or left in the machine that may prevent any part
inside the machine from operating.
Figure 10.4.1.2.2 “Z move” dialog box
10 − 11
10.4.2 Head control
When you select the [2/Head] command on the menu bar, and then the [1/Head
control] command, the dialog box for controlling the head appears as shown in Figure
10.4.2.1.
Each command is described on Table 10.4.2.1.
Figure 10.4.2.1 “Head control” dialog box
Table 10.4.2.1 Description of each command
No. Command Description
1 Nozzle Turns on/off the vacuum condition (ON/OFF), moves the Z-axis
(UP/DOWN) and rotates a nozzle (by the specified angle).
2 Blow Enables a nozzle to blow or not (ON/OFF).
3 Status Displays the each operation control condition and sensor condition.
When you select a button displayed on the dialog box above, the machine controls its
corresponding operation. When you use a keyboard only, press the ENTER key.
When you use a trackball, click the desired button. The control condition is
displayed in real time.
When you click the <THETA> button, the dialog box for rotating a nozzle appears on
the screen as shown in Figure 10.4.2.2. Enter the angle, and then click the
<ROTATE> button. The machine starts rotating the nozzle by the angle you
specified.
10 − 12
Figure 10.4.2.2 “Nozzle rotate” dialog box