KJ-01.02.Instruction Manual.REV.02.pdf - 第378页
14 − 9 14.3 Cleaning 14.3.1 XY axis direct driv e unit Remove dirt, oil, etc. on t he XY axis direct dr ive unit. Figure 14.3.1 ① A T C unit ④ PW B transport unit ② Head unit ⑤ Feeder bank unit ③ X-Y unit
14 − 8
14.2.7 Notice on Electricity
14.2.7.1 General notices
WARNING
Cut off the power to the machine before starting to disconnect or connect
the connectors.
CAUTION
Never use the machine with any voltage other than those specified.
Before switching on the machine, be sure that the machine is in a safe
conditions.
Before switching on the machine, be sure that there is no one who is
working in the machine.
Before switching on the machine, be sure that there are no obstacles
(tools and jigs) left in the machine.
Turn off the machine to supply air.
14.2.7.2 Daily routine checks
1. Make sure that the supply voltage is the rated voltage ± 10%.
2. Make sure that the connectors (of devices such as a keyboard and HOD) are
all seated firmly.
WARNING
To avoid a risk of serious injury or death caused by electric shock hazard,
turn off the main power switch of the house current which is installed in
the building where the machine is used.
Note that it is not the main power switch of the machine.
14 − 9
14.3 Cleaning
14.3.1 XY axis direct drive unit
Remove dirt, oil, etc. on the XY axis direct drive unit.
Figure 14.3.1
① ATC unit ④ PWB transport unit
② Head unit ⑤ Feeder bank unit
③ X-Y unit
14 − 10
(1) X axis
Check
Check that there is no dirt or dust on the rails of the X axis direct drive unit YR
and YL.
(2) Y axis
Check
Check to see if there is no dirt or dust on the rails of the Y axis direct drive unit.
WARNING
To prevent the body from injury which can be caused by accidental
activation of the machine, cut off the power to the machine before starting
to work.
① X-shaft direct-drive unit rail (x 2)
② X-shaft direct-drive unit (x 4)
① Y-shaft frame (x 2)
② Y-shaft direct-drive unit rail (x 2)
③ Y-shaft direct-drive unit (x 4)