Hanwha SM481 PLUS Series Administrator’s Guide Eng.pdf.pdf - 第265页
8-29 Feeder Setup <2Pocket Y -Axis> As shown in the following figure, input the coordi na tes of the center point of any one pocket in the Y direction, the coordinates of the two corners in the diagonal position …
8-28
Fast Flexible Placer SM481(L) PLUS Administrator’s Guide
As per the following figure, input two corner points of pocket No’s. 1, 2 and 3 that
face each other diagonally.
<2Pocket X-Axis>
Enter coordinate of a pocket center in the X direction, coordinate of the diagonal
vertex of the second pocket and the pitches in the X and Y directions.
8-29
Feeder Setup
<2Pocket Y-Axis>
As shown in the following figure, input the coordinates of the center point of any
one pocket in the Y direction, the coordinates of the two corners in the diagonal
position of the second pocket and the pocket pitch in the X and Y directions.
<1Pocket>
As shown in the following figure, input the coordinates of the center point of
pocket No. 1 and the pocket pitch in the X and Y directions.
8-30
Fast Flexible Placer SM481(L) PLUS Administrator’s Guide
<1Pocket with Angle>
This is a teaching method that is useful when the the fiducial camera is movable to
a definite area of the tray and when the tray is installed on an angle, and not in
parallel with the X-axis of the tray. (When 2 Trays on a palette is applied)
1.Select the required tray feeder.
2.Perform pocket teaching in the following order.
(1)Select the [1 Pocket with Angle] in the scroll menu on the right.