Hanwha SM481 PLUS Series Administrator’s Guide Eng.pdf.pdf - 第329页

12-21 LED placement The opti mizer arranges the feeder of the front feeder base first.  Rear The opti mizer arranges the feeder of the rear feeder base first.  <T ape-T ray Mixed Cycle> check box Allows part plac…

12-20

Fast Flexible Placer SM481(L) Administrator’s Guide

perform optimization.

 <Array Options> group

Used when designate display method and optimization option of the MMI step

program when editing the array PCB.

 <Extend> check box

In case of array PCB, <Extend> check box can be ticked. Then, MMI performs

optimization considering one array PCB includes all the array installation

positions. Accordingly, work efficiency is improved.

When the <Extend> check box is not selected, selection of either “By PCB” or

“By Point” is possible.

 <By PCB> option button

Creates the step program so that the optimizer performs optimization only for one

small PCB and performs work for several small PCBs in order.

 <By Point> option button

Performs work in order on the second placement point of the first array after

finishing the work on the first placement point of the array, the first placement

point of the second array, and the first placement point of the last array.

Generally, when many nozzles are replaced, it is efficient to perform work in the

manner applying ‘By Point’.

However, work efficiency may be lowered if there are many defective unit PCB’s.

 <Options> group

Sets the selection condition for the optimizing algorithm executed by the optimizer.

 <Search Depth> combo box

Select the level at which the placement sequence is optimized.

 Quick

Optimizes the placement sequence based on the nearest placement point. In

this method, the time required for the optimization is relatively short.

 Deep

The optimizer compares all possible placement cases for all placement points

to determine the optimum placement sequence. In this method, the time

required for the optimization is relatively long.

 <FDR Base Priority> combo box

Enables to give priority while the optimizer arranges feeder.

 Auto

The optimizer arranges the feeder automatically.

 Front

12-21

LED placement

The optimizer arranges the feeder of the front feeder base first.

 Rear

The optimizer arranges the feeder of the rear feeder base first.

 <Tape-Tray Mixed Cycle> check box

Allows part placement to be performed for the parts to be fed to the tape feeder

while replacing the part in the tray feeder.

 <Pallet Sequence> check box

Optimizes the tray pallet pick-up sequence when executing the optimizer.

 <First Placing Group: Height<= > check box

Used for installing the parts with lower height than the height input in the right

side edit box. Upon selection of this check box, the edit box is activated. Input the

height of the part here.

 <Last Placing Group: Height>= > check box

Used for installing the parts with upper height than the height input in the right

side edit box. Upon selection of this check box, the edit box is activated. Input the

height of the part here.

 <Time(sec)> edit box group

This group inputs the time for executing each movement in the equipment. It is used to

calculate the working time at the optimizer. In addition, the values of the tray Y and

tray Z may have influence on the determination of the work sequence.

Therefore, in order to increase the work efficiency and to get the exact estimate of the

working time, the value as close as possible to the actual value shall be inputted.

 Conveyor: Time (second) taken until the PCB is fixed by the backup table since

being transferred to the workstation.

 Tray Z: Time required for the multi-tray feeder to move in the Z direction (sec)

 Shuttle : Time required for the pad of the shuttle tray to complete one cycle (sec)