Operating Instructions_VF335_en.pdf - 第130页
6|Function description 6.4.3 The status bar The status bar can be found at the lower edge of the screen: user: none Automatic mode Library Soldering program Fig.23: The status bar displays the currently logged in user…
6|Function description
This button is only visible in the [Automatic mode] operating mode. By clicking on
this button, you can stop an active soldering program and set the machine to the
[Maintenance mode]operating mode.
On this regard, please read chapter Selecting and starting a soldering program
If the green symbol is displayed, the machine is in the [Movement off] operating
mode: Click on this button to switch to the [Maintenance mode] operating mode:
Version software. Click on this button to display the version of the currently in-
stalled software. In addition, you may display information about M1 control com-
ponents and visualization components.
NOTE
Exiting the control software
You can exit the control software by clicking the button in the start dialog
.
Also see
2 The [General settings] editing dialog [}131]
6.4.2 The bottom toolbar
This toolbar can be found in the lower part of the start dialog:
user: none maintenance mode
Fig.22: The bottom toolbar
Signal lamp. The button is displayed in each dialog, except for the [Messages] dia-
log, above the status bar. The [Messages] dialog opens when the button is clicked
on. The button will flash as soon as a message is available.
On this regard, please read chapter The [Messages] editing dialog.
Conveyor width adjustment. Clicking on this button opens the [Conveyor width ad-
justment] dialog. In this dialog, you can set the conveyor width of the machine.
On this regard, please read chapter The settings dialog [Width adjustment] [
}240].
All conveyors on. Click on this button to switch on all the machine conveyors simul-
taneously. If a conveyor is switched on, this button is displayed in yellow.
Global settings Click on this button to open the [General] setting dialog.
Ersa GmbH Operating Instructions_VF335_en|Rev. 14|30/11/2017 129/695
6|Function description
6.4.3 The status bar
The status bar can be found at the lower edge of the screen:
user: none Automatic mode Library Soldering program
Fig.23: The status bar displays the currently logged in user and the current operating mode of the machine. In addition, in auto-
matic mode the library and the currently active soldering program are displayed.
[User] The name of the currently logged in user is displayed in the status bar at the
lower left edge of the screen. If a user is logged in, the
button is visible in the
top toolbar of the start dialog. You can click on this button to log out the user. If
this button is not visible, no user is logged in. On this regard, please read chapter
Creating a new user. The green square in the right section of the status bar signals
the operator the control sovereignty as well as the proper communication between
PC and PLC.
Ersa GmbH Operating Instructions_VF335_en|Rev. 14|30/11/2017 130/695
6|Function description
6.5 The [General settings] editing dialog
This dialog is opened with a click on the button in the top toolbar of the start dialog
and contains the following dialogs
– [Profile]
– [User administration]
– [File path]
– [Logging]
These dialogs can be opened by enabling the respective radio buttons:
Profile
User administration
Logging
File path
General settings
Settings
User maintenance mode
Infeed
Profile
LanguageBackground colour
Infeed unit
Flux unit
Preheating
Preheating
Preheating
Preheating
Preheating
Soldering module
Soldering module
Soldering module
Exit unit
Exit
Default
User ersa Maintenance mode
The [General settings] dialog, here the [Profile] radio button was enabled.
Ersa GmbH Operating Instructions_VF335_en|Rev. 14|30/11/2017 131/695