Operating Instructions_VF335_en.pdf - 第259页
6|Function description 6.15.4.2 Determining the [Warm offset] for a wave power of 1% Edit dialog Soldering unit 1 Solder pot 1 Solder pot user: none Maintenance mode Temperature Operation mode Set value Actual value So…
6|Function description
m)Click on the [Active nozzle] checkbox.
ð A [X] is displayed. Your solder nozzle is installed and activated.
ü Accept settings, close dialogs
a) Click on
to accept a setting.
b) Click on
to close a dialog.
Ersa GmbH Operating Instructions_VF335_en|Rev. 14|30/11/2017 258/695
6|Function description
6.15.4.2 Determining the [Warm offset] for a wave power of 1%
Edit dialog Soldering unit 1 Solder pot 1
Solder pot
user:
none
Maintenance mode
Temperature
Operation mode
Set value Actual value
Solder wave off
Module tests
Next test
Wave offset
Switch functions
Manual movement
Set value
Actual value
Automatic positioning
Set no.
Panel
Remaining time
Active tool
Solder
pot 1
Wave power
1
Fig.71: The [Soldering unit 1 Solder pot 1] input dialog
ü To determine the Wave offset for a wave power of [1%]:
ü You have mounted the nozzle
ü The mounted nozzle has been installed and activated in the Data table solder
nozzle
ü A value of [1%] has been entered into the [Wave power] input field.
a) Enable the solder wave.
b) In the [Module tests] frame, click on the
button.
ð A solder wave height test is performed. As soon as the solder wave
touches the test needle, the [Wave offset] status indicator lights up green.
Wait until the solder wave height test has been completed.
c) In the [Manual movement] frame, click on the
button.
ð The solder pot is moved to the [Service] position.
4 mm
d) Check the height of the wave in the nozzle. With a 1% wave power of the max-
imum value, the solder should be in the middle of the nozzle, about 4 mm un-
der the upper edge of the top. In a narrow nozzle, the solder is drawn by capil-
lary action upwards to the sides, while this effect is slighter in a wide nozzle.
Ersa GmbH Operating Instructions_VF335_en|Rev. 14|30/11/2017 259/695
6|Function description
ð If the distance of the solder surface from the nozzle upper edge is less than
4 mm or the solder already overflows:
e) Open the solder nozzle table and slightly reduce the [Offset warm] value, for
example by 500.
ð If no solder cn be seen in the solder nozzle, or the distance of the solder
surface from the nozzle upper edge is more than 4 mm:
f) Open the solder nozzle table and slightly increase the [Offset warm] value, for
example by 500.
g) Save the entries and check the height of the wave in the nozzle again.
h) Repeat steps c to f until the solder in the centre of the nozzle lies approxim-
ately 4 mm below the upper edge of the nozzle.
i) Note down the [Offset warm] determined value, you will need it later.
ð You have correctly set the [Offset warm] value for a wave power of 1%.
Ersa GmbH Operating Instructions_VF335_en|Rev. 14|30/11/2017 260/695