Operating Instructions_VF335_en.pdf - 第336页
8|Service and maintenance 8.6.13 Spray fluxer: Cleaning the whole fluxer area 4 2 2 4 3 1 Fig.108: The whole fluxer area 8 7 5 5 3 6 Fig.109: The whole fluxer area ü To clean the spray fluxer: a) Open doors and hoods…
8|Service and maintenance
8.6.12 Flux reserve: Visual inspection, cleaning
324 41
Fig.107: Spray fluxer connections
ü Visual inspection and cleaning of the storage tank:
a) Visually inspect all hoses and connections (1), (2), (4).
b) Clean dirty components.
c) Lift the flux material tank (3) and carefully move it back and forth.
ð Prevent any flux material leakage. Tightness and firm fit must be guaran-
teed.
d) In the event of flux material leakage or audible wind noise, depressurize the
system.
e) Tighten up leaking connections.
f) Have defective connections replaced by qualified staff.
ð The process has now been completed.
With regard to this, please read Chapters Cleaning agents used [
}300] and Tools
and auxiliary materials [}301].
Ersa GmbH Operating Instructions_VF335_en|Rev. 14|30/11/2017 335/695
8|Service and maintenance
8.6.13 Spray fluxer: Cleaning the whole fluxer area
42 24 31
Fig.108: The whole fluxer area
875 5 36
Fig.109: The whole fluxer area
ü To clean the spray fluxer:
a) Open doors and hoods in the fluxer area.
b) Visual inspection of the whole fluxer area.
c) Travel the spray head into the service position. With regard to this, please read
Chapter [Functional description].
d) Clean covering (1) of the the spray heads. Remove residual flux material with a
cleaning cloth.
e) Travel the spray head into the work position again.
ð The process has now been completed.
ü To clean the whole fluxer area:
Ersa GmbH Operating Instructions_VF335_en|Rev. 14|30/11/2017 336/695
8|Service and maintenance
a) Open the doors and covers in the fluxer area.
b) Visual inspection of the whole fluxer area.
c) Pull out and clean the trough (1).
d) To clean dirty components:
– Toothed belts (2)
– Conveyor profiles and chains (3)
– Sensors (4)
– Sliding surfaces (5) CAUTION!Do not lubricate sliding surfaces!
Smooth and soft running must be guaranteed!
– Spray heads (6)
a) Replace the leather felt (7) in the sensor (8).
b) Reinstall trough (1), close hoods and doors.
ð The process has now been completed.
With regard to this, please read Chapters Cleaning agents used [
}300] and Tools
and auxiliary materials [}301].
Ersa GmbH Operating Instructions_VF335_en|Rev. 14|30/11/2017 337/695