Operating Instructions_VF335_en.pdf - 第691页
10|Appendix 10.3 ESD Foil Also see 2 ESD-Folie [ } 692] Ersa GmbH Operating Instructions_VF335_en|Rev. 14|30/11/2017 691/695
ESD-Certificate
Ersa GmbH, Leonhard-Karl-Str. 24, 97877 WERTHEIM
page 6 of 6
1.4 Conclusion
All components witch came in direct contact with conductive
devices (ESDs), or parts of devices, fullfill the
ESD requirements ref. IEC 61340-5-1.
Wertheim, 10.10.2017
on behalf, Lothar Schwab
R&D soldering machines / ESD-Specialist
Leonhard-Karl-Str.24
97877 WERTHEIM, GERMANY
Telefon: ++49 (0) 9342 / 800-304
Telefax: ++49 (0) 9342 / 800-100
e-mail: lothar.schwab@kurtzersa.de
web: www.kurtzersa.com
Technical Information
Page1of2
Part No.: 5235.DPF.SK100
♦ Untere Gießwiesen 21 ♦ 78247 Hilzingen ♦ Tel.: +49-7731-86880 ♦ Fax: +49-7731-868830
We believe all the information in these pages including technical data to be reliable. However we make no
warranties expressed or implied and assume no liability regarding any use of this information.
V1105
User instructions DPF.SK100
(Part No.: 5235.DPF.SK100 )
Electrostatic dissipative, adhesive backed Polyester film for indoor use
1. Required tools
2. Preparing the surface
3. Applying the film - step by step
4. Maintenance und cleaning
1. Required tools
• Tape-rule
• Ruler
• Non fluffing rag
• Carpet knife
• Rubber wiper (15 - 20 cm width)
• Transparent adhesive tape
• Spray bottle, filled with distillated water and a non-soaping shampoo ( 6 drops for 1 litre
water)
2. Preparing the surface
• Keep the working area free of dust and other dirt
• Clean the surface thorough with a glass or plastic cleaner
• Dry the surface with the wiper
• Remove the residual liquid with the non fluffing rag
3. Applying the film - step by step
Step 1
• Measure the usable area
• Tailor the foil in size, adding 2 cm on each side (the add-on will be cut-off afterwards)
Step 2
• Moisten the surface with the prepared spray bottle. The surface should be wet during the
whole sticking process.
Step 3
• Stick on a piece of adhesive tape at one edge of the foil to easily pull off the transparent
protection film.
• Moisten the adhesive overleaf with the spray bottle
Step 4
• Apply the wet adhesive foil carefully to the wet surface. It is important that both sides are
moist.
• Thread the film carefully to avoid creases
Step 5