Operating Instructions_VF335_en.pdf - 第72页
4|Transport, installation, storage, disposal 4.8 Screw in the adjustable feet. The adjustable feet are supplied with the machine ü Screw in the adjustable feet: a) lift the machine with a forklift and secure the load a…
4|Transport, installation, storage, disposal
4.7 Transporting the unpacked machine
4.7.1 Transport with a forklift
DANGER
Severe or fatal injury due to oveturning machine!
a) The forklift must meet the minimum requirements!
b) Lift the machine always in the center of gravity!
Transport the machine safely
ü Safe machine transport:
a) always lift the load in the middle of the centre of gravity.
ð The designated lifting points are provided with red markings.
b) Always use the marked lifting points to raise the machine!
c) For this purpose, please consider the next figure!
Fig.10: Transport with a forklift
Ersa GmbH Operating Instructions_VF335_en|Rev. 14|30/11/2017 71/695
4|Transport, installation, storage, disposal
4.8 Screw in the adjustable feet.
The adjustable feet are supplied with the machine
ü Screw in the adjustable feet:
a) lift the machine with a forklift and secure the load against falling.
b) Screw in all the adjustable feet.
c) Do not stand or walk under suspended loads.
d) All adjustable feet must be set approximately to the same height.
e) Lower the machine again.
ð The process has now been completed.
Ersa GmbH Operating Instructions_VF335_en|Rev. 14|30/11/2017 72/695
4|Transport, installation, storage, disposal
4.9 Setting up the machine
4.9.1 Clearance space around the machine
With open doors and hoods, a 1 metre wide passageway is required in front of and
behind the machine. On this regard, please observe the following picture:
Fig.11: Clearance space around the machine
Ersa GmbH Operating Instructions_VF335_en|Rev. 14|30/11/2017 73/695