DECAN_F2_Service(Eng_Ver1).pdf - 第106页

5-6 Fast & Flexible Chip Shooter DECAN F2 Service Manual 10) Remove the spli ne downward. 1 1) Replace the Ball sp line with a new one. Ref The part number of the new B all Spline is MC13-000124. 12) Assemble the boa…

5-5

Head

8) Unscrew the fixing bolts securing the Z cap using a hex wrench and remove it.

9) Hold and fix the spline at the gear wrench seat using a spanner and remove the lock

nut with another gear wrench.

5-6

Fast & Flexible Chip Shooter DECAN F2 Service Manual

10) Remove the spline downward.

11) Replace the Ball spline with a new one.

Ref The part number of the new Ball Spline is MC13-000124.

12) Assemble the board in the reverse order of disassembling.

13) When assembling, refer to the following.

Before assembling the Ball Spline to the Head Body, be sure to check whether the

spline becomes stuck when moving it up and down.

Apply EP2 (Grease) to the inserting hole of the ball spline of the main body.

After assembling, measure the movement resistance of the Z Rod Housing and Z Top

Housing.

Measure the movement resistance in the downward direction and check whether it

is less than 0.050kgf using a push-pull gauge.

5-7

Head

Measure the movement resistance from the 2nd section to the 5th section below

the LM Guide tightening bolts.

14) Once the assembling is completed, turn on the main switch on the front of the machine

and boot the PC.

15) Perform the following calibrations.

Fiducial Cameras Offset Calibration

Camera Offset Calibration

Head Z & R Offset calibration

Total Time: 1Hour