DECAN_F2_Service(Eng_Ver1).pdf - 第382页

15-8 Fast & Flexible Chip Shooter DECAN F2 Service Manual Warning If there is no voltage value f or the local power supply on the transformer input terminal, perform setting to the input po rt with the voltage value …

100%1 / 604
15-7
Electric Device
3) After checking the power supply to the place where the machine is being installed,
check whether the measured voltage is normal or not using a digital multimeter. The
default specification of the power supply is single phase, AC 100±5V / 110±5.5V /
120±6V / 200±10V /220±11V / 240±12V.
4) Check the input voltage of the transformer open the Cover of the front of the device.
(Unless there is a special order of the customer, DECAN G2 will be shipped is set to
single-phase 220V.)
Caution If the input voltage of the transformer was changed, the
power sticker attached on the machine must be changed
according to the changed voltage. Mark the power supply
on the S/N nameplate in oil magic ink. Otherwise, the
machine may be damaged due to the input of incorrect
power supply.
15-8
Fast & Flexible Chip Shooter DECAN F2 Service Manual
Warning If there is no voltage value for the local power supply on the
transformer input terminal, perform setting to the input port
with the voltage value one step higher.
Ref The part number of the new Transfomer is J2605005A.
5) After completing the change, check the input voltage by measuring it again.
15-9
Electric Device
15.4. Terminal Block Ass’y
15.4.1. Required Tools
Crosshead (Phillips) screwdriver and flathead screwdriver
T Wrench or Hex Wrench
15.4.2. Terminal Block Assembly Configuration
Warning If the main circuit breaker located at the lower left on the
rear side of the machine is not turned off before performing
service, serious injury may occur. Perform servicing with the
power supply to the motor cut off without fail.
1) Part list of Terminal Block Assy
No Part No. Part Name Unit
Quantity
1 J3501040A MAGNETIC CONTACTOR LC1D096BD,
DC24V, 1A1B
1
2 EP07-000576 BREAKER,CIRCUIT SH202-C16 2
3 EP07-000731 BREAKER,CIRCUIT SH203-C16 1
4 J7051105B DIN RAIL J7051105B 1
5 J3601018A FUSE 250V 5A 3
6 J3601019A FUSE 250V 10A 2
7 EP21-000093 BLOCK,TERMINAL 281-611 5
8 EP21-000094 BLOCK,TERMINAL 2002-1301 10
9 EP21-000095 BLOCK,TERMINAL 2002-1401 10
10 EP21-000096 BLOCK,TERMINAL 2002-2201 2