DECAN_F2_Service(Eng_Ver1).pdf - 第84页

3-22 Fast & Flexible Chip Shooter DECAN F2 Service Manual PCB. 3.2.4. Checking Manual Operation 1) Press the ‘READY’ button on the OP panel. 2) Click the Home menu to home the machine. 3) 각 항목의 동작을 실행햐여 각 항목이 정상적으로 동…

3-21

Installation & Operation

Machines manufactured not in accordance with the SMEMA code such as SIMENS,

SANYO and TDK (RX-11), and machines without dual contact interface shall be

examined specially.

Machine interface must be decided. (Select 2-contact method or SMEMA method

suitable for the user’s environment.)

Select SYS.SETUP menu and lower menu of the conveyor.

Select ‘Stand Alone’, or SSA Type (2 contacts), or SMEMA in the ‘In (Before)

and Out (After)’ combo box of the inline protocol area.

Stand Alone: The connection is not established between machines. Setup is

made during manual operation.

SSA Type: The PCB flows only if the contact is connected in the next

machine.

SMEMA: The ready signal is given by the previous machine (24V), and the

contact is connected in the next machine.

Check if the interface between connected machines operates normally by using

the MMI bypass function. At this time, perform test using at least 3 pieces of

3-22

Fast & Flexible Chip Shooter DECAN F2 Service Manual

PCB.

3.2.4. Checking Manual Operation

1) Press the ‘READY’ button on the OP panel.

2) Click the Home menu to home the machine.

3) 각 항목의 동작을 실행햐여 각 항목이 정상적으로 동작하는지 확인하십시오.

4) 정상인 경우 생산 절차에 따라서 장비를 가동하십시오.

3.2.5. Warming Up

1) After the machine installation, warm up the machine for 30 minutes.

3-23

Installation & Operation