DECAN_F2_Service(Eng_Ver1).pdf - 第354页

14-14 Fast & Flexible Chip Shooter DECAN F2 Service Manual 7) When assembling the board, connect the cables referring to the following figure.

14-13

Board

5) Remove the cable connected to the board.

6) Unscrew the fixing bolts(4-M3*6) securing the Board using a wrench and remove it.

Ref The part number of the new Board is AM03-005341A.

14-14

Fast & Flexible Chip Shooter DECAN F2 Service Manual

7) When assembling the board, connect the cables referring to the following figure.

14-15

Board

14.3. Y Frame Duct

14.3.1. Required Tools

 Crosshead (Phillips) screwdriver and flathead screwdriver

 T Wrench or Hex Wrench

 Nipper (Remove the Cable Tie)

14.3.2. Z Motor AMP Board Replacement Procedure

1) Close the PC as usual and turn off the main switch at the front of the machine.

2) Turn off the main power supply to the machine.

Warning Before servicing the machine, turn off the power switch

located at the front bottom as well as the main circuit

breaker at the rear bottom of the machine. Otherwise,

serious personal injury may occur. Perform servicing with

the power supply to the machine cut off without fail.

Warning Be sure to wear anti-electrostatic gloves when servicing the

machine.

3) Unscrew the Fastener securing the Cover Driver Y using a wrench and remove it.

4) Remove the cable connected to the board.