DECAN_F2_Service(Eng_Ver1).pdf - 第191页

8-1 BUT Chapter8. BUT 8.1. Cylinder 8.1.1. Required Tools  T W rench (other tools supplied) or Hex W rench  T orque W rench 8.1.2. Air Cylinder R eplacement Procedure 1) Manipulate the teaching box to move th e head as…

8-1

BUT

Chapter8. BUT

8.1. Cylinder

8.1.1. Required Tools

 T Wrench (other tools supplied) or Hex Wrench

 Torque Wrench

8.1.2. Air Cylinder Replacement Procedure

1) Manipulate the teaching box to move the head assembly to both ends as much as

possible.

2) Manipulate the teaching box to increase the conveyor width.

3) Unscrew the fixing screws (8-M4*8) securing the Back Up Plate and remove it.

4) Remove the air tube connected to the cylinder fitting.

5) Unscrew the fixing screws (M4-4) that secure the cylinder to the upper driving link

8-2

Fast & Flexible Chip Shooter DECAN F2 Service Manual

and replace the module. At this time, do not remove the upper plate.

6) Remove it as shown in the following figure, the Cylinder.

1: Cylinder Joint : J6619062A

2: Ring Fixer : J7053795A

3: Cylinder Joint Pin : J70530794B

4: Cylinder : J67010088B

Ref The part number of the new Cylinder is J67010088B.

7) After assembling with a new Cylinder, refer to the following.

Secure 2 sets of the ring fixer on the cylinder body side with set screws first and then

slightly tighten the ring fixer on the cylinder joint with set screws (M4 - 2 sets).