DECAN_F2_Service(Eng_Ver1).pdf - 第251页

12-1 Motor Driver Chapter12. Motor Driver 12.1. Part of Motor Driver 1: EP06-000390A(CONTROL-DRIVER-STEBRO-SP B-WW -V1.0) EP06-000391A(CONTROL-DRIV ER-STEBRO-SPB-ST -V1.0) 2: J31531051A(SER VO MOTOR DRIVER A5E MADHT1505E…

12-1

Motor Driver

Chapter12. Motor Driver

12.1. Part of Motor Driver

1: EP06-000390A(CONTROL-DRIVER-STEBRO-SPB-WW-V1.0)

EP06-000391A(CONTROL-DRIVER-STEBRO-SPB-ST-V1.0)

2: J31531051A(SERVO MOTOR DRIVER A5E MADHT1505E)

3: J31531049A(SERVO MOTOR DRIVER A5E MCDHT3520E)

4: EP06-000316(SERVO CONTROL DRIVER MDDHT5540LA2)

12.2. Servo Motor Driver Trouble Inspection

12.2.1. Checking Points for Servo Motor Driver Trouble

Occurrence of Abnormality -> Dynamic Braker /Motor Current /Servo Output /Alarm

Output -> Dynamic Braker Release

When this sequence is activated, motor stops and generate alarm.

12-2

Fast & Flexible Chip Shooter DECAN F2 Service Manual

1) If the trouble related to servomotor occur, alarm code is indicated on LED of front

panel.

2) At this time, servo motor power is OFF. For the release of the alarm, it is required that

procedure 1 [EMG Alarm: EMG -> STOP -> RESET -> READY] or procedure 2

[General Alarm: STOP -> RESET -> READY] is performed.

Caution For alarms related to power, turn off power and turn on

power.

3) For alarm caused by OVERLOAD, normal clear is possible in 10 seconds or more. So,

press the ‘READY’ button to supply power to the servo motor in 10 seconds or more

after pressing the ‘RESET’ button.

4) If troubles are caused by cable connection for the terminal of servomotor and improper

wiring, ensure that checking wiring is performed after motor power is off.

5) If the servomotor without mechanical problem does not drive, check if the parameter

is normal. And then if the same trouble ouccur again, replace the mortor drive.

6) If the drive of motor is not stable and acceleration/deceleration is improper, the

following checks should be performed;

Check if servomotor has mechnical problem

Check if servomotor parameter setup is normal

Check if the primary input voltage is acceptable