DECAN_F2_Service(Eng_Ver1).pdf - 第164页

6-14 Fast & Flexible Chip Shooter DECAN F2 Service Manual 6.3. Conveyor Motor 1: Entry / Exit Zone Frame W idth adjustment Motor 2: E ntry / Exit Zone Rear Frame W idth adjustment Motor 3: E ntry / Exit Zone Fr ont F…

6-13

Conveyor

Ref Tension: 350±20 Hz

Tension Measurement location:

You can adjust the Tension to move to the left and right Motor.

6-14

Fast & Flexible Chip Shooter DECAN F2 Service Manual

6.3. Conveyor Motor

1: Entry / Exit Zone Frame Width adjustment Motor

2: Entry / Exit Zone Rear Frame Width adjustment Motor

3: Entry / Exit Zone Front Frame PCB transfer Motor

4: Entry / Exit Zone Rear Frame PCB transfer Motor

5: Work Zone Front Fix Frame PCB transfer Motor

6: Work Zone Front Move Frame PCB transfer Motor

7: Work Zone Power transmission Motor

6.3.1. Required Tools

 Tension Gage (U-505)

 Flathead screwdriver

 T-Wrench (other tools supplied) or Hex Wrench

6.3.2. Entry / Exit Zone Frame Width adjustment Motor Replacement Procedure

1) Manipulate to increase the conveyor width as wide as possible.

2) Close the PC as usual and turn off the main switch at the front of the machine.

3) Please remove the Cable that is connected to the Motor.

6-15

Conveyor

4) Unscrew the fixing bolts (2-M5*10) securing the Motor using a wrench and remove it.

5) Unscrew the setscrew securing the motor to remove it and remove the motor pulley

and set screw.

6) Replace the Motor with a new one.

Ref The part number of the new Motor is EP08-000204.

7) When assembling the motor-pulley, refer to the following.