DECAN_F2_Service(Eng_Ver1).pdf - 第519页

Calibration

17-106

Fast & Flexible Chip Shooter DECAN F2 Service Manual

CautionAn alarm which has a “ * “ mark at the side of the Alarm Code No.

in the above table cannot be cleared. In such case, turn the power

off and then on again to release the alarm if the machine is in

normal condition

When an error occurs in the internal control circuit of the Servo-

Amp. due to excessive noise, etc., the following alarm codes may

be displayed.

In this case, immediately turn off the power and check both the

cable wiring and the connection of the frame ground

If any alarm that is not included in the above alarm code table

occurs, input the parameters of the Servo-Amp. again using the

exclusive program. Next, turn the power off and then on again,

and check the machine to determine if there still is a problem

If the alarm still continues after taking the above third measure, it is

caused by a damaged amplifier in most cases. In this case, change

the Servo-amp.

Calibration