DECAN_F2_Service(Eng_Ver1).pdf - 第207页
9-7 Y Frame Duct 9.2. FAN 9.2.1. Required Tools Crosshead (Phillips) screwdriv er and flathead screwdriver T W rench or Hex W rench Nipper (Remove the Cable Tie) 9.2.2. FAN Replacement Procedure 1) Close the PC as …
9-6
Fast & Flexible Chip Shooter DECAN F2 Service Manual
4) Remove the Cable that is connected to the Board.
5) Unscrew the fixing bolts (6-M3*6)securing the 16 Axis Board using a wrench and
remove it.
6) Assemble in the Y Fame Duct a new Board.
Ref The part number of the new Board is J91741337A.
9-7
Y Frame Duct
9.2. FAN
9.2.1. Required Tools
Crosshead (Phillips) screwdriver and flathead screwdriver
T Wrench or Hex Wrench
Nipper (Remove the Cable Tie)
9.2.2. FAN Replacement Procedure
1) Close the PC as usual and turn off the main switch at the front of the machine
2) Turn off the main power supply to the machine
Warning Before servicing the machine, turn off the power switch
located at the front bottom as well as the main circuit
breaker at the rear bottom of the machine. Otherwise,
serious personal injury may occur. Perform servicing with
the power supply to the machine cut off without fail.
Warning Be sure to wear anti-electrostatic gloves when servicing the
machine.
3) Remove the Cover Loosen the Fastener to secure the Cover Driver Y.
9-8
Fast & Flexible Chip Shooter DECAN F2 Service Manual
4) Remove the Cable that is connected to the FAN.
5) Unscrew the fixing bolts (4-M4*30)securing the FAN using a wrench and remove it.
6) Assemble in the Y Fame Duct a new Board.
Ref The part number of the new FAN is CS02-000006.