00195982-03_SM_SWS_EN.pdf - 第131页

7 Die ejector 7.3 Replacing spare parts Service Manual SIPLACE Wafer System (SWS) 11/2018 131 Fig.151: ► Remove the two screws (3) and take the board off the support block. Unplug the connector from the dual light barri…

7 Die ejector

7.3 Replacing spare parts

130 Service Manual SIPLACE Wafer System (SWS) 11/2018

Fig.149:

► Pull the vacuum hose off.

You now need to dismantle the fork light barrier board. To do so, proceed as follows:

Fig.150:

► Remove the two screws(2) (Allen key 2.5) and then take off the fork light barrier (1).

7 Die ejector

7.3 Replacing spare parts

Service Manual SIPLACE Wafer System (SWS) 11/2018 131

Fig.151:

► Remove the two screws (3) and take the board off the support block.

Unplug the connector from the dual light barrier board [00385741-xx]. There are two options for un-

plugging the connector:

Fig.152:

► Option 1: Try to pull the connector up and off with as little effort as possible, as shown in the

diagram. It is helpful if the index finger has contact with the white housing of the pug and the

cable is held by the thumb.

CAUTION

► Only use minimum effort on the connector. If this is not possible, proceed as follows

(option 2):

7 Die ejector

7.3 Replacing spare parts

132 Service Manual SIPLACE Wafer System (SWS) 11/2018

Fig.153:

► Option 2: Push the tip of a screwdriver (5) sideways between the two connection pins on the

connector(4).

Turn slightly to lever the connector out of the holder.

Fig.154:

► Loosen the four screws fastening the Z axis die ejector.

NOTICE

The four fastening screws (6) each have a loss prevention lock [03075495‑xx](7). This loss

prevention lock is located between the support plate and the Z axis die ejector, in a shallow

sink. The fastening screws(6) do not need to be completely removed as they can be held

by the last turns of the thread in the loss prevention lock(7).

The lock thread is at the base of the shallow sink, meaning that there is about 2 mm lock

thread before the screw could fall out.

► However, if the screws are removed completely, make sure that these loss prevention

locks are not lost when the Z axis die ejector is removed.