00195982-03_SM_SWS_EN.pdf - 第338页

13 BoxPC, GALIL cards and axis control 13.1 Removing and replacing the BoxPC 338 Service Manual SIPLACE Wafer System (SWS) 11/2018 13.1.3 Removing the BoxPC Fig.482: ► First push the BoxPC slightly towards the back, unt…

100%1 / 506
13 BoxPC, GALIL cards and axis control
13.1 Removing and replacing the BoxPC
Service Manual SIPLACE Wafer System (SWS) 11/2018 337
Number Connection Connection on back Type
6 AXIS 9-10 (to wafer handler and lift) AXIS 9-10 100pin cable
7 USB-IO (analog IO from flip unit and die at-
tach)
USB 7 USB2.0
8 Memory stick connection (on keyboard) USB 5 USB2.0
9 USB can converter (CAN in / CAN out from
CA)
USB 1 USB2.0
10 Vision dongle (always remains on the SWS!) USB 10 Green dongle
11 AXIS 5-8 (to slip unit and die attach) AXIS 5/6 (8) 100pin cable
12 VGA to monitor VGA VGA
13 LAN cable to line control LAN1 Cat5 red
14 LAN cable to service computer LAN2 Cat5 red
●
All cables are labeled.
●
All the allocated terminals on the BoxPC have the same designations.
Fig.481:
► If disconnecting or connecting the cables causes problems, open the cable ties.
► After successfully replacing and connecting all cables, you must fix them properly into place
with cable ties.
These fixtures serve as strain relief.
The 100 pin connectors (5, 6 und 11) are particularly sensitive to vibration and changes in
tension.
13 BoxPC, GALIL cards and axis control
13.1 Removing and replacing the BoxPC
338 Service Manual SIPLACE Wafer System (SWS) 11/2018
13.1.3 Removing the BoxPC
Fig.482:
► First push the BoxPC slightly towards the back, until the head of the screw is on the drilled
hole.
► Now lift the BoxPC up and remove it from the SWS.
Fig.483:
► Place the BoxPC down again.
13 BoxPC, GALIL cards and axis control
13.1 Removing and replacing the BoxPC
Service Manual SIPLACE Wafer System (SWS) 11/2018 339
13.1.4 Fitting the new BoxPC
Fig.484:
► Set the main switch (1) to ON - I - !
This is important because the main switch will no longer be accessible once the SWS has
been fitted in the CA machine!
► Insert the Vision dongle into the USB slot (2) provided.
The Vision dongle always remains with the SWS, it may never be exchanged for that from an-
other SWS.
ð After importing the BoxPC backup, the corresponding license is imported to the BoxPC
and the dongle releases this software for use!
► After this, refit the BoxPC into the position provided on the side cover plate.