00195982-03_SM_SWS_EN.pdf - 第444页

16 Software 16.2 Installation of operating system 444 Service Manual SIPLACE Wafer System (SWS) 11/2018 16.2.3.2 Selecting the SWS location The SWS location can be selected in the GUI in more recent GUI versions (>3.0…

100%1 / 506
16 Software
16.2 Installation of operating system
Service Manual SIPLACE Wafer System (SWS) 11/2018 443
Fig.668:
► If you have saved the Halcon file on a USB stick because the software package was not yet
available, insert this USB stick into the USB port behind the SWS keyboard (see above).
It does not matter in which folder on the USB stick the license was saved.
► Switch over to the page Service -> Machine configuration -> SW configuration and select
"Copy Halcon license".
Fig.669:
The license will now be searched for in all folders on the inserted USB stick and then automatically
copied into the license folder on the SWS BoxPC.
► Restart the SWS, to activate the Halcon license and use the Vision system.
16 Software
16.2 Installation of operating system
444 Service Manual SIPLACE Wafer System (SWS) 11/2018
16.2.3.2 Selecting the SWS location
The SWS location can be selected in the GUI in more recent GUI versions (>3.02.x).
If the location was correctly selected during the GUI installation, there is no more need for action.
► To select the location, switch over to the page "Service -> Machine configuration -> SW
configuration" and click on "Select SWS location".
Fig.670:
The location can then be selected in the window shown below.
► To apply the change in location, you need to restart the SWS.
Fig.671:
► If this function is not available in older GUI versions, you will need to set the location using the
Setup Tool.
16 Software
16.2 Installation of operating system
Service Manual SIPLACE Wafer System (SWS) 11/2018 445
Setting the location in the setup tool.
This is only required if the location was incorrectly set during the GUI installation and a resetting of
the location in the GUI is not possible (see last chapter).
► Go to the setup tool start menu and select "SWS Basesettings".
Fig.672: Setup tool menu - SWS base settings
► Confirm your selection of SWS Basesettings with Enter.
Fig.673: Location number
► Select Location.
► Confirm with Enter.
► The serial number of the SWS can also be altered in the above menu, if needed.
Fig.674: Setting the location number
► Go to Location and select the number of the relevant location (1-4).
In our example, the SWS is at location 4.
► Confirm with Enter.