00195982-03_SM_SWS_EN.pdf - 第432页

16 Software 16.2 Installation of operating system 432 Service Manual SIPLACE Wafer System (SWS) 11/2018 16.2.1.8 Restoring the system with the recovery DVD If there are problems installing the new operating system, you c…

100%1 / 506
16 Software
16.2 Installation of operating system
Service Manual SIPLACE Wafer System (SWS) 11/2018 431
Fig.644:
► Press the ESC key 3x.
ð The following message will appear:
Fig.645:
► Select Yes and press Enter.
► Remove the written DVD from the BoxPC of the SWS and label it with the SWS serial number
and the date of creation.
ð You should now be back in the start menu of the setup tool (see below).
Fig.646:
► Select Restart Application and press Enter, to restart the GUI or Shutdown to shut down
the system.
16 Software
16.2 Installation of operating system
432 Service Manual SIPLACE Wafer System (SWS) 11/2018
16.2.1.8 Restoring the system with the recovery DVD
If there are problems installing the new operating system, you can restore the system as follows
using the recovery DVD:
► Open the bottom lift door and swing the entire lift to the side.
► Place the recovery DVD in the BoxPC of the SWS. Check the label of the DVD (SWS serial
number) to make sure that the DVD belongs to the SWS for which you want to restore the
system. Make sure that you are using the most recent recovery DVD.
Fig.647:
► Restart the SWS system. During booting, press the Del button to access the BIOS menu.
► Make sure that the CD/DVD drive is in first place in the order of booting.
► Continue the boot procedure.
ð The system should start from the recovery DVD and the following start screen should be
shown.
Fig.648:
► Select Automatic (Unattended) Recover sws and press Enter.
ð The restoring process will now start. This will take some minutes.
ð After successfully restoring the system, the following message will be shown:
16 Software
16.2 Installation of operating system
Service Manual SIPLACE Wafer System (SWS) 11/2018 433
Fig.649:
► Enter 3 and press Enter. The system will now reboot in safe mode from the recovery DVD.
In the event of a PC problem, it is advisable to create a new recovery DVD every month so that you
always have the current system status available.
In addition, save the product and calibration data on a USB stick every week and place this with the
SWS.
16.2.1.9 Adding network addresses
The installation of the operating system resets the network address to the default addresses.
It is therefore important to make a note of these addresses, especially the one for the eth0 interface
(customer network interface), before installing the operating system.
► Start the setup tool with Ctrl+Alt+Q.
ð The start screen will appear.
Fig.650:
► Select SetupTool and press Enter.
ð The following login box will appear.