RS-1_instruction manual.pdf - 第144页

Part 1 B asic O peration Chapter 2 Pr oduction 2- 33 2.8 Produ ction Screen Starting up the Pr oduction screen When you se lect the “Pr oduct” button from the menu of the main scre en, and then t he [PWB Productio n] com…

Part 1 Basic Operation Chapter 2 Production

2-32

スライドプレート②

ATCブラケット①

スライドプレート②が開いた状態

ノズル⑨

平部

Slide plate ②

ATC bracket ①

When the slid plate ② is opened

Nozzle ⑨

Flat portion

1. Press the <Open> button to open the slide plate 2.

2. Mount or dismount the nozzle ⑨ on/from the ATC while aligning the flat portion of the

nozzle ⑨ with the long hole of the ATC bracket ①.

CAUTION

- Replace the nozzle to the position at which it was used to be

located. If you have replaced the nozzle with another one, change

the settings of the “ATC nozzle setup” menu of the “Machine setup”

utility.

- Do not attach the nozzle onto the head directly. (Or the contact

surface with laser gets stained and it may cause an error.)

Part 1 Basic Operation Chapter 2 Production

2-33

2.8 Production Screen

Starting up the Production screen

When you select the “Product” button from the menu of the main screen, and then the [PWB

Production] command or when you select the “PWB Production” button on the Application shortcut

tab, the following production requirements screen appears.

Specify the desired production requirements on this screen (see Section 2.8.2 “Production

requirements screen”).

Part 1 Basic Operation Chapter 2 Production

2-34

Production conditions screen

When you start up the Production utility, the production requirements setting screen appears.

Set the requirements for each production mode: PWB production, Trail, and Dry run.

• Common setting items:

Set the common conditions regardless the selected mode: “PWB production,” “Trial” or “Dry

run.”

• Individual setting items:

Select the production mode among the “PWB production,” “Trial,” and “Dry run” to set the

requirements for the selected mode.

Common setting items

(1) No of PWBs to be prod. (produced)

Enter the planned number of PWBs to be produced. The planned number of PWBs set at the

previous production appears here at first.

When the machine uses a dual-lane conveyor, this number indicates the total number of PWBs

that will be produced with the front and rear lanes. When the total number of PWBs produced

with the front and rear lanes reaches this number, the machine finishes producing a PWB.

When you display this screen for the first time, “1” appears here. When you enter “0” into the

“No. of PWBs to be prod.” field, the system will to produce PWBs infinitely.

(2) No of produced PWBs

Shows the number of PWBs that have been already produced. This number is reset to “0” at

start of production. (Note that this number is not reset when you start continuous production.)

When the machine uses the dual-lane conveyor, this number indicates the total number of

PWBs already produced with the front and rear lanes.

Normally, the initial value displayed here is set to “0.” However, when you check the item

“Accumulated planned number of boards produced” on the “Production (Display)” tag of the

“Operation option” menu, the number of PWBs that were produced during the previous

production appears here. If you start production in this condition, the system counts the

number of produced PWBs from this displayed number and continues production until the

number reaches the planned number of PWBs.

When production is aborted or ended, the number of PWBs that have been produced already

appears here.

Individual setting items

Common setting items