RS-1_instruction manual.pdf - 第525页
Part 1 B asic O peration Chapter 4 Cr eating a Produc tion Progra m 4- 190 (6) F EED When you teach t he comp onent pic k - up pos i tion, the < FEED> butt on indi cating the feed er number is displaye d on the scr…
Part 1 Basic Operation Chapter 4 Creating a Production Program
4-189
When you press the button shown on the figure below, the teaching screen is minimized as an
icon, and then moves to the lower left side.
When you press this icon again, the screen regains its original dimensions.
When you press the icon, the
screen regains its original
Minimized as an icon.
Part 1 Basic Operation Chapter 4 Creating a Production Program
4-190
(6) FEED
When you teach the component pick-up position, the <FEED> button indicating the feeder number
is displayed on the screen. When you press this <FEED> button, the corresponding feeder feeds
once.
When a component can be cued or it is set to be cued, the <CUEING> button appears on the
screen. When you press the <CUEIING> button, the corresponding feeder cues a component.
The feeder feeds a component.
The feeder cues a component.
Part 1 Basic Operation Chapter 4 Creating a Production Program
4-191
4.5.4.2 Teaching a mark
The system teaches information required to recognize a mark. To start teaching a mark, move
the cursor to the mark name of data to be taught, and then select the “Teaching” button in the
Operation area. Note that you have to enter the XY coordinates of a mark with the Program
Editor in advance.