RS-1_instruction manual.pdf - 第896页

Part 2 D etaile d Descript ion of E ach Functi on Chapter 12 Handling th e Optional Device s 12 - 12 12.2.1 Rep lacement of tr ay hol der 1) Insert the slide r ail tip in the guide r ail groove of a rear bank. 2) When in…

Part 2 Detailed Description of Each Function Chapter 12 Handling the Optional Devices

12-11

12.2 Electric bank multi-tray holder

This tray holder is equipped with one tray, and can be installed on the rear bank so that the head of

the main unit can pick up a component directly from this holder.

When the tray size is small, several trays can be attached on the holder to allow this holder to

function as a multi-tray holder.

Full type

Half type

Longitudinal direction 65 mm to 320 mm 65 mm to 155 mm

Horizontal direction 65 mm to 259.5 mm 65 mm to 259.5 mm

Thickness

5 mm to 11 mm

(from the bottom of a tray to the top of an IC)

Number of occupied positions

* A number of available places at the rear side. Full type: 2 tray holders, - Half type: 4 tray

holders

* If the thickness is not shown above, contact our sales person in charge.

Do not replace the tape feeder with another one while the X- or Y-axis, or head

is operating. It may cause a serious injury to the operator or damage the

machine itself since the tape feeder touches the operating parts.

Do not dismount the tape feeder while the X- or Y-axis or head is operating.

Be sure to open the safety cover before replacing a feeder with another one.

After setting feeders required for PWB production at the positions specified with

a production program respectively, set feeders not to be used for production

such as an 8-mm tape feeder at all the positions not occupied with the feeders

above so that any finger or hand cannot be put between the set feeders to

secure your safety.

- Full size - Half size

① Side plate

② Tray lock lever

③ Slide rail

④ Guide pin

①

②

③

④

①

②

③

④

CAUTION

Part 2 Detailed Description of Each Function Chapter 12 Handling the Optional Devices

12-12

12.2.1 Replacement of tray holder

1) Insert the slide rail tip in the guide rail groove of a rear bank.

2) When inserting the tray holder up to the middle, grasp the side plate and the lock holder, and

open the lock holder.

Slide rail tip

Guide rail

Side plate

Lock holder

Part 2 Detailed Description of Each Function Chapter 12 Handling the Optional Devices

12-13

3) Insert the tray holder, separate the side plate and the lock holder in the place where the side

plate is in contact with the POSITIONING_PLATE, and lock it with the lock holder.

Note) Check to see if the tray holder is locked with the lock holder.

4) Detach it with the reverse procedures of the above.

Lock holder

Side plate

POSITIONING_PLATE