RS-1_instruction manual.pdf - 第321页
Part 1 Basic Operat ion Chapter3 D aily maintenance 3- 29 Lubrication it em Transport screw shaft Lubrication fr equency : Every month T ool to be used: Brus h Grease to be us ed: 6459 Grease N 1) Screw sha ft 1 on each …
Part 1 Basic Operation Chapter3 Daily maintenance
3-28
Lubrication item
X/Y axis ball screw
Lubrication frequency:
Every 2 months
Tool to be used: Hand grease pump Grease to be used: NSL Grease
Where to lubricate
X axis ball screw (grease nipple)
1) Use a grease gun to insert grease from the grease nipple of the X axis ball screw.
Grease gun (pump)/nozzle to be used
40098975 NSK_HGP
40106055 FLEXIBLE_NOZZLE
∗ The oil can be applied even when using the nozzle that is
assembled to the grease gun as standard shown above.
However, it is convenient to use the FLEXIBLE_NOZZLE
(40106055).
* Where to inject grease
Ball screw grease nipple
X/Y axis ball screws (at three locations)
The grease for the LM guide is different from that for ball screws.
Do not use them in a mixed form.
CAUTION
To prevent the body from injury which can be caused by accidental
activation of the machine, cut off the power to the machine before starting
to work.
DANGER
Part 1 Basic Operation Chapter3 Daily maintenance
3-29
Lubrication item
Transport screw shaft
Lubrication frequency:
Every month
Tool to be used: Brush Grease to be used: 6459 Grease N
1) Screw shaft 1 on each side, right and left
Apply grease to the entire surface of ①.
Lubrication item
Transport guide shaft
Lubrication frequency:
Every month
Tool to be used: Brush Grease to be used: 6459 Grease N
1) Guide shaft: Two pieces on each of the left side and the right side (four pieces in total)
Apply grease to the entire surface of ①.
1) Two drive shafts both on the left and right sides: total four
Apply grease to the entire surface of ①.
Lubrication item
Drive shaft
(Single-lane conveyor specifications)
Lubrication frequency:
Every month
Tool to be used: Brush
Grease to be used: 6459 Grease N
①
*
①
①
Part 1 Basic Operation Chapter3 Daily maintenance
3-30
Lubrication item
Ball screws and Spline shaft
Lubrication frequency:
two months
Tool to be used: Brush Grease to be used: CG2
1) Apply a light coating of grease (CG2 grease) to the ball screws ① rails.
Apply a light coating of grease (CG2 grease) to the spline shaft axis ②.
After fitting grease to the spline shaft axis sufficiently with moving the Z axis up and down, remove
extra grease with cloth or similar matter so that it cannot be splattered.
CAUTION
Never apply any grease other than CG2 grease to the parts above.
When grease (CG2 grease) is mixed with another type of grease, it may
be separated from the screw, rails or shaft and run down.
Spline shafts
②
Figure of the head viewed from the top
Figure of the head viewed from the bottom
8-nozzle head
Ball screws
①