RS-1_instruction manual.pdf - 第318页
Part 1 Basic Operat ion Chapter3 D aily maintenance 3- 26 Where to clean Coplanarity sensor (option) Cleaning fr equency : everyday How to clean Cleaning of dust an d/or a f oreign s ubstanc e T ools to be used: Waste c …
Part 1 Basic Operation Chapter3 Daily maintenance
3-25
Where to clean
Load control unit (option)
Cleaning frequency:
Every month
How to clean
Cleaning of dust and/or a foreign substance from
the load measurement surface
Tools to be used:
Waste cloth
1) Check to see if there is not any foreign substance such as dust on the load measurement surface.
If there is any foreign substance, clean it.
Where to clean
CVS (option)
Cleaning frequency:
Every week
How to clean
Cleaning of dust and/or a foreign
substance
Tools to be used:
Waste cloth
Recommended solution:
IPA
1) If any dirt and dust is stuck to the topside of the contact, clean it with cloth damped with alcohol. If
dirt or dust is stuck to the topside, the CVS may not be able to check an element normally.
2) If any foreign substance such as an element is caught in the slit section of the contact or around it,
remove it with a tool such as tweezers.
If a foreign substance is caught in such a section, the CVS may not be able to check an element
normally.
When removing a foreign substance, be careful not to damage any bundled wires of the contact.
Load control unit (load cell)
Load measurement
Slit section
Bundled wires
Contact
Part 1 Basic Operation Chapter3 Daily maintenance
3-26
Where to clean
Coplanarity sensor (option)
Cleaning frequency:
everyday
How to clean
Cleaning of dust and/or a foreign substance
Tools to be used:
Waste cloth
1) Wipe off dust and stains of the filter unit (the projection window/photodetection window) with dry
clean waste cloth or gauze.
Projection window
Photodetection window
Part 1 Basic Operation Chapter3 Daily maintenance
3-27
3.3 Lubrication
Lubrication item
XY-shaft direct drive unit
Lubrication frequency:
Every 6 months
Tool to be used: Grease gun Grease to be used: 6459 Grease N
Where to lubricate
XY-shaft direct drive unit (grease nipple)
1) Use a grease gun to insert grease from the grease nipple of the XY-shaft direct drive unit.
Grease gun/nozzle to be used
40127626 GREASE_GUN
40127627 GREASE_GUN_NOZZLE
∗ Replace the nozzle that is assembled to the grease gun as standard shown above with the
GREASE_GUN_NOZZLE (40127627).
*Where to inject grease
LM guide grease nipple
X-shaft direct drive unit rail: four positions
on the top, bottom, right and left sides.
Y-shaft direct drive unit rail: four positions
on the top, bottom, right and left sides.
The grease for the LM guide is different from that for ball screws.
Do not use them in a mixed form.
CAUTION
To prevent the body from injury which can be caused by accidental activation of
the machine, cut off the power to the machine before starting to work.
DANGER