RS-1_instruction manual.pdf - 第921页
Part 2 D etaile d Descript ion of E ach Functi on Chapter 12 Handling th e Optional Device s 12 - 37 12.6.2.4 Production When “Cutt er” is checked of f in [Option device en able] in Machine setup, the cuter is operat ed …
Part 2 Detailed Description of Each Function Chapter 12 Handling the Optional Devices
12-36
12.6.2.2 Manual Control
When you select [Other] – [Cutter control] on the manual control screen, the cutter control screen
is started. For the operating method, refer to “9.6.9 Cutter control.”
12.6.2.3 Machine Information
Select [Cutter usage information] on the machine information screen to display the cutter usage
information screen. You can check the number of cutter operations. For the operating method,
refer to “10.3.12 Cutter usage information.”
Part 2 Detailed Description of Each Function Chapter 12 Handling the Optional Devices
12-37
12.6.2.4 Production
When “Cutter” is checked off in [Option device enable] in Machine setup, the cuter is operated in a
certain cycle during production.
(1) Cutter operation timing
When production is started, the tape cutter functions at constant intervals. When production
is finished, the tape cutter operation is completed.
1) Cutter operation stop timing
The cyclic tape cut operation is stopped in the status shown below.
- Pause
- Non-production
2) Cutter single operation timing
The tape cut operation is performed once at the timing shown below.
- Production completion
- Pause
- <Cutter> button is pressed on the “Pause” screen.
(2) <Cutter> button
The <Cutter> button is displayed in the “Stop” dialog box.
When you press the <Cutter> button, the “Question” message appears.
Pressing <OK> will start the tape cut operation.
- “Stop” dialog box
Part 2 Detailed Description of Each Function Chapter 12 Handling the Optional Devices
12-38
- “Retry list” dialog box
1. Do not open the guide section of the cutter unit with your hand or put your hand
in the cutter unit.
Or you may have your finger cut with the blade of the cutter or the movable part.
2. Do not put any substance on the cutter unit or apply any load to it.
Or the guide or cover of the cutter unit may be deformed, so it may hurt you,
malfunction or generate abnormal noise.
Note